Z8F2480AN020SG Zilog, Z8F2480AN020SG Datasheet - Page 157

• Manufacturer Part Number: Z8F2480AN020SG
• Description: MCU 8BIT 24KB FLASH 44LQFP
• Manufacturer: Zilog
• Series: Encore!® XP®r

Specifications of Z8F2480AN020SG

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: I²C, IrDA, LIN, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, LED, LVD, POR, PWM, Temp Sensor, WDT
• Number Of I /o: 37
• Program Memory Size: 24KB (24K x 8)
• Program Memory Type: FLASH
• Ram Size: 3K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 3.6 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 44-LQFP
• Processor Series: Z8F248x
• Core: eZ8
• Data Bus Width: 8 bit
• Data Ram Size: 2 KB
• Interface Type: I2C, SPI, UART
• Maximum Clock Frequency: 20 MHz
• Number Of Programmable I/os: 37
• Number Of Timers: 3
• Maximum Operating Temperature: + 70 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: 0 C
• On-chip Adc: 10 bit, 8 Channel
• For Use With: 770-1002 - ISP 4PORT ZILOG Z8 ENCORE! MCU269-4643 - KIT DEV Z8 ENCORE XP 28-PIN269-4630 - DEV KIT FOR Z8 ENCORE 8K/4K269-4629 - KIT DEV Z8 ENCORE XP 28-PIN269-4628 - KIT DEV Z8 ENCORE XP 8-PIN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details
• Other names: 269-4676

PS025011-1010
Transmitting Data Using Polled Method
Follow the steps below to transmit data using the polled-operating method:
1. Write to the LIN-UART Baud Rate High and Low Byte registers to set the 
2. Enable the LIN-UART pin functions by configuring the associated GPIO port pins 
3. If MULTIPROCESSOR mode is appropriate, write to the LIN-UART Control 1
4. Set the MULTIPROCESSOR Mode Select (
5. Write to the LIN-UART Control 0 Register to:
Figure 20. LIN-UART Asynchronous Data Format without Parity
appropriate baud rate.
for alternate-function operation.
Register to enable MULTIPROCESSOR (9-bit) mode functions.
mode.
(a) Set the transmit enable bit (
(b) If parity is appropriate and MULTIPROCESSOR mode is not enabled, set the
(c) Set or clear the
Figure 21. LIN-UART Asynchronous Data Format with Parity
parity enable bit (PEN) and select either even-or-odd parity (
using the CTS pin.
CTSE
P R E L I M I N A R Y
bit to enable or disable control from the remote receiver
TEN
) to enable the LIN-UART for data transmission.
MPEN
) to enable MULTIPROCESSOR
Z8 Encore! XP
Product Specification
PSEL
®
).
F1680 Series
LIN-UART
143