HD64F36912GFH Renesas Electronics America, HD64F36912GFH Datasheet - Page 142

• Manufacturer Part Number: HD64F36912GFH
• Description: IC H8 MCU FLASH 8K 32-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H Tinyr

Specifications of HD64F36912GFH

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 12MHz
• Connectivity: I²C, SCI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 18
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 1.5K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 32-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 7 ROM
7.5
There are three kinds of flash memory program/erase protection; hardware protection, software
protection, and error protection.
7.5.1
Hardware protection refers to a state in which programming/erasing of flash memory is forcibly
disabled or aborted because of a transition to reset, subsleep mode or standby mode. Flash
memory control register 1 (FLMCR1), flash memory control register 2 (FLMCR2), and erase
block register 1 (EBR1) are initialized. In a reset via the RES pin, the reset state is not entered
unless the RES pin is held low until oscillation stabilizes after powering on. In the case of a reset
during operation, hold the RES pin low for the RES pulse width specified in the AC
Characteristics section.
7.5.2
Software protection can be implemented against programming/erasing of all flash memory blocks
by clearing the SWE bit in FLMCR1. When software protection is in effect, setting the P or E bit
in FLMCR1 does not cause a transition to program mode or erase mode. By setting the erase block
register 1 (EBR1), erase protection can be set for individual blocks. When EBR1 is set to H'00,
erase protection is set for all blocks.
7.5.3
In error protection, an error is detected when CPU runaway occurs during flash memory
programming/erasing, or operation is not performed in accordance with the program/erase
algorithm, and the program/erase operation is aborted. Aborting the program/erase operation
prevents damage to the flash memory due to overprogramming or overerasing.
When the following errors are detected during programming/erasing of flash memory, the FLER
bit in FLMCR2 is set to 1, and the error protection state is entered.
Rev. 3.00 Sep. 14, 2006 Page 112 of 408
REJ09B0105-0300
When the flash memory of the relevant address area is read during programming/erasing
(including vector read and instruction fetch)
Immediately after exception handling excluding a reset during programming/erasing
When a SLEEP instruction is executed during programming/erasing
Program/Erase Protection
Hardware Protection
Software Protection
Error Protection