HD64F36912GFH Renesas Electronics America, HD64F36912GFH Datasheet - Page 206

• Manufacturer Part Number: HD64F36912GFH
• Description: IC H8 MCU FLASH 8K 32-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H Tinyr

Specifications of HD64F36912GFH

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 12MHz
• Connectivity: I²C, SCI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 18
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 1.5K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 32-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 12 Timer W
Figure 12.8 shows an example of buffer operation when the GRA is set as an input-capture
register and GRC is set as the buffer register for GRA. TCNT operates as a free-running counter,
and FTIOA captures both rising and falling edge of the input signal. Due to the buffer operation,
the GRA value is transferred to GRC by input-capture A and the TCNT value is stored in GRA.
12.4.2
In PWM mode, PWM waveforms are generated by using GRA as the period register and GRB,
GRC, and GRD as duty registers. PWM waveforms are output from the FTIOB, FTIOC, and
FTIOD pins. Up to three-phase PWM waveforms can be output. In PWM mode, a general register
functions as an output compare register automatically. The output level of each pin depends on the
corresponding timer output level set bit (TOB, TOC, and TOD) in TCRW. When TOB is 1, the
FTIOB output goes to 1 at compare match A and to 0 at compare match B. When TOB is 0, the
FTIOB output goes to 0 at compare match A and to 1 at compare match B. Thus the compare
match output level settings in TIOR0 and TIOR1 are ignored for the output pin set to PWM mode.
If the same value is set in the cycle register and the duty register, the output does not change when
a compare match occurs.
Figure 12.9 shows an example of operation in PWM mode. The output signals go to 1 and TCNT
is cleared at compare match A, and the output signals go to 0 at compare match B, C, and D
(TOB, TOC, and TOD = 1: initial output values are set to 1).
Rev. 3.00 Sep. 14, 2006 Page 176 of 408
REJ09B0105-0300
PWM Operation
H'FFFF
H'DA91
H'5480
H'0245
H'0000
FTIOA
GRA
GRC
Figure 12.8 Buffer Operation Example (Input Capture)
TCNT value
H'0245
H'5480
H'0245
H'DA91
H'5480
Time