HD6417727F160CV Renesas Electronics America, HD6417727F160CV Datasheet - Page 283

• Manufacturer Part Number: HD6417727F160CV
• Description: IC SH MPU ROMLESS 240QFN
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417727F160CV

• Core Processor: SH-3 DSP
• Core Size: 32-Bit
• Speed: 160MHz
• Connectivity: FIFO, SCI, SIO, SmartCard, USB
• Peripherals: DMA, LCD, POR, WDT
• Number Of I /o: 104
• Program Memory Type: ROMless
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 1.7 V ~ 2.05 V
• Data Converters: A/D 6x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 240-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

3. When data access (address only) is specified as a break condition:
4. When data access (address + data) is specified as a break condition:
8.3.7
1. Setting PCTE in BRCR to 1 enables PC traces. When branch (branch instruction, repeat, and
2. The branch address before branch occurs can be calculated from the address and the pointer
The PC value is the address of the instruction to be executed following the instruction that
matched the break condition. The instruction that matched the condition is executed and the
break occurs before the next instruction is executed.
The PC value is the start address of the instruction that follows the instruction already executed
when break processing started up. When a data value is added to the break conditions, the
place where the break will occur cannot be specified exactly. The break will occur before the
execution of an instruction fetched around the data access where the break occurred.
interrupt) is generated, the address from which the branch source address can be calculated and
the branch destination address are stored in BRSR and BRDR, respectively. The branch
address and the pointer, which corresponds to the branch, are included in BRSR.
stored in BRSR. The expression from BSA (the address in BRSR), PID (the pointer in BRSR),
and IA (the instruction address before branch occurs) is as follows: IA = BSA – 2 * PID.
Notes are needed when an interrupt (a branch) is issued before the branch destination
instruction is executed. In case of the next figure, the instruction “Exec” executed immediately
before branch is calculated by IA = BSA – 2 * PID. However, when branch “branch” has delay
slot and the destination address is 4n + 2 address, the address “Dest” which is specified by
branch instruction is stored in BRSR (Dest = BSA). Therefore, as IA = BSA – 2 * PID is not
applied to this case, this PID is invalid. The case where BSA is 4n + 2 boundary is applied
only to this case and then some cases are classified as follows:
Exec: branch
Dest: instr
Int: interrupt routine
If the PID value is odd, instruction buffer indicates PID+2 buffer. However, these expressions
in this table are accounted for it. Therefore, the true branch source address is calculated with
BSA and PID values stored in BRSR.
PC Trace
interrupt
Dest
(not executed)
Rev.6.00 Mar. 27, 2009 Page 225 of 1036
Section 8 User Break Controller
REJ09B0254-0600