DS21Q55 Maxim Integrated Products, DS21Q55 Datasheet - Page 46

• Manufacturer Part Number: DS21Q55
• Description: IC TXRX QUAD T1/E1/J1 SCT 256BGA
• Manufacturer: Maxim Integrated Products

Specifications of DS21Q55

• Function: Transceiver
• Interface: E1, J1, T1
• Number Of Circuits: 4
• Voltage - Supply: 3.14 V ~ 3.47 V
• Current - Supply: 75mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 256-BGA
• Includes: BERT Generator and Detector, Dual HDLC Controllers
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Power (watts): -

5.1 Power-Up Sequence
The DS21Q55 contains an on-chip power-up reset function that automatically clears the writeable register
space immediately after power is supplied to the DS21Q55. The user can issue a chip reset at any time.
Issuing a reset disrupts traffic flowing through the DS21Q55 until the device is reprogrammed. The reset
can be issued through hardware using the TSTRST pin or through software using the SFTRST function in
the master mode register. The LIRST (LIC2.6) should be toggled from 0 to 1 to reset the line interface
circuitry. (It takes the DS21Q55 about 40ms to recover from the LIRST bit being toggled.) Finally, after
the TSYSCLK and RSYSCLK inputs are stable, the receive and transmit elastic stores should be reset
(this step can be skipped if the elastic stores are disabled).
5.1.1 Master Mode Register
Register Name:
Register Description:
Register Address:
Bit #
Name
Default
Bit 0/Software-Issued Reset (SFTRST). A 0-to-1 transition causes the register space in the device to be cleared.
A reset clears all configuration and status registers. The bit automatically clears itself when the reset has completed.
Bit 1/Device Operating Mode (T1/E1). Used to select the operating mode of the framer/formatter (digital) portion
of the 2156. The operating mode of the LIU must also be programmed.
Bits 2, 3/Test Mode Bits (TEST0, TEST1). Test modes are used to force the output pins of the device into known
states. This can facilitate the checkout of assemblies during the manufacturing process and also be used to isolate
devices from shared buses.
Bits 4 to 7/Unused, must be set to 0 for proper operation
TEST1
0
0
1
1
0 = T1 operation
1 = E1 operation
TEST0
—
7
0
0
1
0
1
Operate normally
Force all output pins into tri-state (including all I/O pins and parallel port pins)
Force all output pins low (including all I/O pins except parallel port pins)
Force all output pins high (including all I/O pins except parallel port pins)
—
MSTRREG
Master Mode Register
00h
6
0
—
5
0
—
4
0
Effect On Output Pins
46 of 237
TEST1
0
3
TEST0
2
0
T1/E1
1
0
SFTRST
0
0