DS21Q55 Maxim Integrated Products, DS21Q55 Datasheet - Page 93

• Manufacturer Part Number: DS21Q55
• Description: IC TXRX QUAD T1/E1/J1 SCT 256BGA
• Manufacturer: Maxim Integrated Products

Specifications of DS21Q55

• Function: Transceiver
• Interface: E1, J1, T1
• Number Of Circuits: 4
• Voltage - Supply: 3.14 V ~ 3.47 V
• Current - Supply: 75mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 256-BGA
• Includes: BERT Generator and Detector, Dual HDLC Controllers
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Power (watts): -

14.2 Transmit Signaling
Figure 14-2. Simplified Diagram of Transmit Signaling Path
14.2.1 Processor-Based Mode
In processor-based mode, signaling data is loaded into the transmit signaling registers (TS1–TS16) by the
host interface. On multiframe boundaries, the contents of these registers are loaded into a shift register for
placement in the appropriate bit position in the outgoing data stream. The user can employ the transmit
multiframe interrupt in status register 4 (SR4.4) to know when to update the signaling bits. The user need
not update any transmit signaling register for which there is no change-of-state for that register.
Each transmit signaling register contains the robbed-bit signaling (T1) or TS16 CAS signaling (E1) for
two time slots that are inserted into the outgoing stream, if enabled to do so through T1TCR1.4 (T1
mode) or E1TCR1.6 (E1 mode). In T1 mode, only TS1–TS12 are used.
Signaling data can be sourced from the TS registers on a per-channel basis by using the software
signaling insertion enable registers, SSIE1–SSIE4.
14.2.1.1 T1 Mode
In T1 ESF framing mode, there are four signaling bits per channel (A, B, C, and D). TS1–TS12 contain a
full multiframe of signaling data. In T1 D4 framing mode, there are only two signaling bits per channel
(A and B). In T1 D4 framing mode, the framer uses the C and D bit positions as the A and B bit positions
for the next multiframe. In D4 mode, two multiframes of signaling data can be loaded into TS1–TS12.
The framer loads the contents of TS1–TS12 into the outgoing shift register every other D4 multiframe. In
D4 mode, the host should load new contents into TS1–TS12 on every other multiframe boundary and no
later than 120µs after the boundary.
T1/E1 DATA
STREAM
ONLY APPLIES TO T1 MODE
0
1
B7
PER-CHANNEL
SSIE1 - SSIE4
CONTROL
T1TCR1.4
1
0
93 of 237
REGISTERS
SIGNALING
TRANSMIT
PER-CHANNEL
CONTROL
PCPR.3
0
1
SIGNALING
BUFFERS
TSER
TSIG