ATmega16U2 Atmel Corporation, ATmega16U2 Datasheet - Page 129

• Manufacturer Part Number: ATmega16U2
• Manufacturer: Atmel Corporation

Specifications of ATmega16U2

• Flash (kbytes): 16 Kbytes
• Pin Count: 32
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 12
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 22
• Ext Interrupts: 21
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Uart: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 0.5
• Eeprom (bytes): 512
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 2.7 to 5.5
• Operating Voltage (vcc): 2.7 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 5
• Input Capture Channels: 1
• Pwm Channels: 4
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

16.11 Register Description
16.11.1
7799D–AVR–11/10
TCCR1A – Timer/Counter1 Control Register A
Figure 16-13. Timer/Counter Timing Diagram, with Prescaler (f
•
•
•
The COMnA[1:0], COMnB[1:0], and COMnC[1:0] control the output compare pins (OCnA,
OCnB, and OCnC respectively) behavior. If one or both of the COMnA[1:0] bits are written to
one, the OCnA output overrides the normal port functionality of the I/O pin it is connected to. If
one or both of the COMnB[1:0] bits are written to one, the OCnB output overrides the normal
port functionality of the I/O pin it is connected to. If one or both of the COMnC[1:0] bits are writ-
ten to one, the OCnC output overrides the normal port functionality of the I/O pin it is connected
to. However, note that the Data Direction Register (DDR) bit corresponding to the OCnA, OCnB
or OCnC pin must be set in order to enable the output driver.
When the OCnA, OCnB or OCnC is connected to the pin, the function of the COMnx[1:0] bits is
dependent of the WGMn[3:0] bits setting.
when the WGMn[3:0] bits are set to a normal or a CTC mode (non-PWM).
and ICF n
Bit
(0x80)
Read/Write
Initial Value
Bit 7:6 – COMnA1:0: Compare Output Mode for Channel A
Bit 5:4 – COMnB1:0: Compare Output Mode for Channel B
Bit 3:2 – COMnC1:0: Compare Output Mode for Channel C
(PC and PFC PWM)
TOVn
(CTC and FPWM)
(Update at TOP)
TCNTn
TCNTn
as TOP)
OCRnx
(clk
clk
clk
I/O
(FPWM)
I/O
Tn
/8)
(if used
COM1A1
R/W
7
0
COM1A0
TOP - 1
TOP - 1
R/W
6
0
Old OCRnx Value
COM1B1
R/W
5
0
COM1B0
TOP
TOP
R/W
Table 16-1
4
0
ATmega8U2/16U2/32U2
COM1C1
R/W
3
0
shows the COMnx[1:0] bit functionality
BOTTOM
TOP - 1
COM1C0
New OCRnx Value
R/W
2
0
clk_I/O
/8)
WGM11
BOTTOM + 1
R/W
1
0
TOP - 2
WGM10
R/W
0
0
TCCR1A
129