HD6417011VX20V Renesas Electronics America, HD6417011VX20V Datasheet - Page 224

• Manufacturer Part Number: HD6417011VX20V
• Description: MPU 5V 0K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7010r

Specifications of HD6417011VX20V

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 20MHz
• Connectivity: EBI/EMI, SCI
• Peripherals: POR, PWM
• Number Of I /o: 11
• Program Memory Type: ROMless
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 7x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

Clock: The SCI’s transmit/receive clock is an internal clock generated by the on-chip baud rate
generator.
SCI Initialization (Asynchronous Mode): Before transmitting or receiving, clear the TE and RE
bits to 0 in the serial control register (SCR), then initialize the SCI as follows.
When changing the operation mode or communication format, always clear the TE and RE bits to
0 before following the procedure given below. Clearing TE to 0 sets TDRE to 1 and initializes the
transmit shift register (TSR). Clearing RE to 0, however, does not initialize the RDRF, PER, FER,
and ORER flags and receive data register (RDR), which retain their previous contents.
Figure 12.3 is a sample flowchart for initializing the SCI. The procedure is as follows (the steps
correspond to the numbers in the flowchart):
1. Select the clock source in the serial control register (SCR). Leave RIE, TIE, TEIE, MPIE, TE
2. Select the communication format in the serial mode register (SMR).
3. Write the value corresponding to the bit rate in the bit rate register (BRR).
4. Wait for at least the interval required to transmit or receive one bit, then set TE or RE in the
214
and RE cleared to 0.
serial control register (SCR) to 1. Also set RIE, TIE, TEIE and MPIE as necessary. Setting TE
or RE enables the SCI to use the TxD or RxD pin. The initial states are the marking transmit
state, and the idle receive state (waiting for a start bit).