HD6417616 RENESAS [Renesas Technology Corp], HD6417616 Datasheet - Page 502

• Manufacturer Part Number: HD6417616
• Description: 32-Bit RISC Microcomputer SuperH™ RISC engine Family/SH7600 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 11 Direct Memory Access Controller (DMAC)
Bit 2—Address Error Flag Bit (AE): This flag indicates that an address error has occurred in the
DMAC. When the AE bit is set to 1, DMA transfer cannot be enabled even if the DE bit in the
DMA channel control register (CHCR) is set to 1. To clear the AE bit, read 1 from it and then
write 0. Operation is performed up to the DMAC transfer being executed when the address error
occurred. AE is initialized to 0 by a reset and in standby mode. It retains its value when the
module standby function is used.
Bit 1—NMI Flag Bit (NMIF): This flag indicates that an NMI interrupt has occurred. When the
NMIF bit is set to 1, DMA transfer cannot be enabled even if the DE bit in the DMA channel
control register (CHCR) and the DME bit are set to 1. To clear the NMIF bit, read 1 from it and
then write 0. Operation is completed up to the end of the DMAC transfer being executed when
NMI was input. When the NMI interrupt is input while the DMAC is not operating, the NMIF bit
is set to 1. The NMIF bit is initialized to 0 by a reset or in the standby mode. It retains its value
when the module standby function is used.
Bit 0—DMA Master Enable Bit (DME): Enables or disables DMA transfers on all channels. A
DMA transfer becomes enabled when the DE bit in the CHCR and the DME bit are set to 1. For
this to be effective, the TE bit in CHCR and the NMIF and AE bits must all be 0. When the DME
bit is cleared, all channel DMA transfers are aborted. DME is initialized to 0 by a reset and in
standby mode. It retains its value when the module standby function is used.
Rev. 2.00 Mar 09, 2006 page 476 of 906
REJ09B0292-0200
Bit 2: AE
0
1
Bit 1: NMIF
0
1
Bit 0: DME
0
1
Description
No DMAC address error
To clear the AE bit, read 1 from it and then write 0
Address error by DMAC
Description
No NMIF interrupt
To clear the NMIF bit, read 1 from it and then write 0
NMIF interrupt has occurred
Description
DMA transfers disabled on all channels
DMA transfers enabled on all channels
(Initial value)
(Initial value)
(Initial value)