HD6432160 RENESAS [Renesas Technology Corp], HD6432160 Datasheet - Page 665

• Manufacturer Part Number: HD6432160
• Description: Hitachi 16-Bit Single-Chip Microcomputer
• Manufacturer: RENESAS [Renesas Technology Corp]

Function
Peripheral
modules
Note:* “Halted (retained)” means that internal register values are retained. The internal state is
26.3
The CPU makes a transition to medium-speed mode as soon as the current bus cycle ends
according to the setting of the SCK2 to SCK0 bits in SBYCR. In medium-speed mode, the CPU
operates on the operating clock (ø/2, ø/4, ø/8, ø/16, or ø/32). On-chip peripheral modules other
than the bus masters always operate on the system clock (ø).
In medium-speed mode, a bus access is executed in the specified number of states with respect to
the bus master operating clock. For example, if ø/4 is selected as the operating clock, on-chip
memory is accessed in 4 states, and internal I/O registers in 8 states.
By clearing all of bits SCK2 to SCK0 to 0, a transition is made to high-speed mode at the end of
the current bus cycle.
If a SLEEP instruction is executed when the SSBY bit in SBYCR is cleared to 0, and the LSON
bit in LPWRCR is cleared to 0, a transition is made to sleep mode. When sleep mode is cleared by
an interrupt, medium-speed mode is restored. When the SLEEP instruction is executed with the
SSBY bit set to 1, the LSON bit cleared to 0, and the PSS bit in TCSR (WDT_1) cleared to 0,
operation shifts to software standby mode. When software standby mode is cleared by an external
interrupt, medium-speed mode is restored.
When the 5(6 pin is set low and medium-speed mode is cancelled, operation shifts to the reset
state. The same applies in the case of a reset caused by overflow of the watchdog timer.
“operation suspended.”
“Halted (reset)” means that internal register values and internal states are initialized.
In module stop mode, only modules for which a stop setting has been made are halted
(reset or retained).
PWM
PWMX
XBS,
Keyboard
buffer
controller
D/A
A/D
RAM
I/O
Medium-Speed Mode
High-
Speed
Function-
ing
Medium-
Speed
Function-
ing
Sleep
Function-
ing
Function-
ing (DTC)
Function-
ing
Module
Stop
Function-
ing/Halted
(reset)
Function-
ing
Function-
ing
Watch
Halted
(reset)
Retained
Retained
Sub-
Active
Halted
(reset)
ing
ing
Function-
Function-
Rev. 2.0, 08/02, page 625 of 788
Retained
Function-
ing
Sub-
Sleep
Halted
(reset)
Retained
Retained
Software
Standby
Halted
(reset)
Retained
High
impedance
Hardware
Standby
Halted
(reset)