MA330013 Microchip Technology, MA330013 Datasheet - Page 163

• Manufacturer Part Number: MA330013
• Description: MODULE PLUG-IN DSPIC33 100TQFP
• Manufacturer: Microchip Technology

Specifications of MA330013

• Accessory Type: Plug-In Module (PIM) - dsPIC33FJ256MC710
• Tool / Board Applications: General Purpose MCU, MPU, DSP, DSC
• Mcu Supported Families: DsPIC33
• Silicon Manufacturer: Microchip
• Core Architecture: DsPIC
• Core Sub-architecture: DsPIC33
• Silicon Core Number: DsPIC33F
• Silicon Family Name: DsPIC33FJxxMCxxx
• Rohs Compliant: Yes
• For Use With: DM330023 - BOARD DEV DSPICDEM MCHV
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With/related Products: Explorer 16 (DM240001 or DM240002)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Not applicable / Not applicable

11.0
The Timer1 module is a 16-bit timer, which can serve
as the time counter for the real-time clock, or operate
as a free-running interval timer/counter. Timer1 can
operate in three modes:
• 16-bit Timer
• 16-bit Synchronous Counter
• 16-bit Asynchronous Counter
Timer1 also supports these features:
• Timer gate operation
• Selectable prescaler settings
• Timer operation during CPU Idle and Sleep
• Interrupt on 16-bit Period register match or falling
FIGURE 11-1:
© 2007 Microchip Technology Inc.
Note:
modes
edge of external gate signal
TIMER1
This data sheet summarizes the features
of this group of dsPIC33F devices. It is not
intended to be a comprehensive reference
source. To complement the information in
this data sheet, refer to the “dsPIC30F
Family Reference Manual” (DS70046).
SOSCO/
SOSCI
Set T1IF
T1CK
16-BIT TIMER1 MODULE BLOCK DIAGRAM
TGATE
0
1
Reset
Equal
SOSCEN
Comparator
TMR1
PR1
Preliminary
Q
Q
Gate
Sync
CK
T
CY
D
Figure 11-1 presents a block diagram of the 16-bit timer
module.
To configure Timer1 for operation:
1.
2.
3.
4.
5.
6.
Set the TON bit (= 1) in the T1CON register.
Select the timer prescaler ratio using the
TCKPS<1:0> bits in the T1CON register.
Set the Clock and Gating modes using the TCS
and TGATE bits in the T1CON register.
Set or clear the TSYNC bit in T1CON to select
synchronous or asynchronous operation.
Load the timer period value into the PR1
register.
If interrupts are required, set the interrupt enable
bit, T1IE. Use the priority bits, T1IP<2:0>, to set
the interrupt priority.
TSYNC
1x
01
00
0
1
TON
TGATE
TCS
Sync
dsPIC33F
TCKPS<1:0>
1, 8, 64, 256
Prescaler
2
DS70165E-page 161