US38024-BAG1 Renesas Electronics America, US38024-BAG1 Datasheet - Page 312

• Manufacturer Part Number: US38024-BAG1
• Description: DEV EVALUATION KIT H8/38024
• Manufacturer: Renesas Electronics America
• Series: H8®r
• Type: MCUr

Specifications of US38024-BAG1

• Contents: 2G (Second-generation) Evaluation Board, HEW debugger support, Cable and CD-ROM
• For Use With/related Products: H8/38024
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Section 9 Timers
9.5.3
The noise canceler consists of a digital low-pass filter that eliminates high-frequency component
noise from the pulses input from the input capture input pin. The noise canceler is set by NCS * in
PMR2.
Figure 9.9 shows a block diagram of the noise canceler.
The noise canceler consists of five latch circuits connected in series and a match detector circuit.
When the noise cancellation function is not used (NCS = 0), the system clock is selected as the
sampling clock. When the noise cancellation function is used (NCS = 1), the sampling clock is the
internal clock selected by CKS1 and CKS0 in TMG, the input capture input is sampled on the
rising edge of this clock, and the data is judged to be correct when all the latch outputs match. If
all the outputs do not match, the previous value is retained. After a reset, the noise canceler output
is initialized when the falling edge of the input capture input signal has been sampled five times.
Therefore, after making a setting for use of the noise cancellation function, a pulse with at least
five times the width of the sampling clock is a dependable input capture signal. Even if noise
cancellation is not used, an input capture input signal pulse width of at least 2φ or 2φ
necessary to ensure that input capture operations are performed properly
Note: * An input capture signal may be generated when the NCS bit is modified.
Figure 9.10 shows an example of noise canceler timing.
Rev. 8.00 Mar. 09, 2010 Page 290 of 658
REJ09B0042-0800
Input capture
input signal
Sampling clock
Noise Canceler
Sampling
D
clock
Latch
C
Δt: Set by CKS1 and CKS0
Q
Δt
D
Figure 9.9 Noise Canceler Block Diagram
Latch
C
Q
D
Latch
C
Q
D
Latch
C
Q
D
Latch
C
Q
detector
Match
SUB
is
Noise
canceler
output