MC912DG128ACPV Freescale Semiconductor, MC912DG128ACPV Datasheet - Page 144

• Manufacturer Part Number: MC912DG128ACPV
• Description: IC MCU 128K FLASH 8MHZ 112-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HC12r

Specifications of MC912DG128ACPV

• Core Processor: CPU12
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: CAN, I²C, SCI, SPI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 2K x 8
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x8/10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 112-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Resets and Interrupts
10.8.2 External Reset
10.8.3 COP Reset
Technical Data
144
source of reset in a system. The POR circuit only initializes internal
circuitry during cold starts and cannot be used to force a reset as system
voltage drops.
It is important to use an external low voltage reset circuit (for example:
MC34064 or MC33464) to prevent power transitions or corruption of
RAM or EEPROM.
The CPU distinguishes between internal and external reset conditions
by sensing whether the reset pin rises to a logic one in less than nine E-
clock cycles after an internal device releases reset. When a reset
condition is sensed, an internal circuit drives the RESET pin low and a
clocked reset sequence controls when the MCU can begin normal
processing. In the case of a clock monitor error, a 4096 cycle oscillator
start-up delay is imposed before the reset recovery sequence starts
(reset is driven low throughout this 4096 cycle delay). The internal reset
recovery sequence then drives reset low for 16 to 17 cycles and releases
the drive to allow reset to rise. Nine E-clock cycles later the reset pin is
sampled. If the pin is still held low, the CPU assumes that an external
reset has occurred. If the pin is high, it indicates that the reset was
initiated internally by either the COP system or the clock monitor.
To prevent a COP reset from being detected during an external reset,
hold the reset pin low for at least 32 cycles. To prevent a clock monitor
reset from being detected during an external reset, hold the reset pin low
for at least 4096 + 32 cycles. An external RC power-up delay circuit on
the reset pin is not recommended — circuit charge time can cause the
MCU to misinterpret the type of reset that has occurred.
The MCU includes a computer operating properly (COP) system to help
protect against software failures. When COP is enabled, software must
write $55 and $AA (in this order) to the COPRST register in order to keep
a watchdog timer from timing out. Other instructions may be executed
between these writes. A write of any value other than $55 or $AA or
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
Resets and Interrupts
MC68HC912DT128A — Rev 4.0
MOTOROLA