MC912DG128ACPV Freescale Semiconductor, MC912DG128ACPV Datasheet - Page 173

• Manufacturer Part Number: MC912DG128ACPV
• Description: IC MCU 128K FLASH 8MHZ 112-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HC12r

Specifications of MC912DG128ACPV

• Core Processor: CPU12
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: CAN, I²C, SCI, SPI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 2K x 8
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x8/10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 112-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

12.6.11 Pseudo-STOP exit without Limp Home mode, clock monitor enabled
12.6.12 Pseudo-STOP exit without Limp Home mode, clock monitor disabled
12.6.13 Summary of STOP and pseudo-STOP Mode Exit Conditions
MC68HC912DT128A — Rev 4.0
MOTOROLA
CAUTION:
(NOLHM=1, CME=1, DLY=X)
If the NOLHM bit is set and the CME (or FCME) bits are set, a clock
monitor failure is detected when a STOP instruction is executed and the
MCU resets via the clock monitor reset vector.
(NOLHM=1, CME=0, DLY=1)
If NOLHM is set to 1 and the CME and FCME bits are cleared, the limp
home clock is not used. In this mode, crystal activity is the only method
by which the device may recover from Pseudo-STOP. The device will
start execution with the EXTALi clock following 4096 XCLK cycles.
(NOLHM=1, CME=0, DLY=0)
If NOLHM is set to 1 and the CME and FCME bits are cleared, the limp
home clock is not used. In this mode, crystal activity is the only method
by which the device may recover from Pseudo-STOP. The device will
start execution with the EXTALi clock following 16 XCLK cycles.
Due to switching of the clock this configuration is not recommended.
Table 12-1
and pseudo-STOP modes using Interrupt, Key-interrupt and XIRQ.
A short RESET pulse should not be used to exit stop or pseudo-STOP
mode because Limp Home mode is automatically entered after RESET
(when V
oscillator startup time (as in power on reset) in order to remove the risk
of code runaway.
Freescale Semiconductor, Inc.
For More Information On This Product,
DDPLL
and
Go to: www.freescale.com
=V
Table 12-2
DD
Clock Functions
). The RESET wakeup pulse must be longer than the
summarise the exit conditions from STOP
Limp-Home and Fast STOP Recovery modes
Clock Functions
Technical Data
173