MC912DG128ACPV Freescale Semiconductor, MC912DG128ACPV Datasheet - Page 453

• Manufacturer Part Number: MC912DG128ACPV
• Description: IC MCU 128K FLASH 8MHZ 112-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HC12r

Specifications of MC912DG128ACPV

• Core Processor: CPU12
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: CAN, I²C, SCI, SPI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 2K x 8
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x8/10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 112-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

23.4 Printed Circuit Board Guidelines
MC68HC912DT128A — Rev 4.0
MOTOROLA
Printed Circuit Boards (PCBs) are the board of choice for volume
applications. If designed correctly, a very low noise system can be built
on a PCB with consequently good EMI/EMC performances. If designed
incorrectly, PCBs can be extremely noisy and sensitive modules, and
the CGM could be disrupted. Some common sense rules can be used to
prevent such problems.
•
•
•
•
•
•
Freescale Semiconductor, Inc.
For More Information On This Product,
Use a ‘star’ style power routing plan as opposed to a ‘daisy chain’.
Route power and ground from a central location to each chip
individually, and use the widest trace practical (the more the chip
draws current, the wider the trace). NEVER place the MCU at the
end of a long string of serially connected chips.
When using PCB layout software, first direct the routing of the
power supply lines as well as the CGM wires (crystal oscillator and
PLL). Layout constraints must be then reported on the other
signals and not on these ‘hot’ nodes. Optimizing the ‘hot’ nodes at
the end of the routing process usually gives bad results.
Avoid notches in power traces. These notches not only add
resistance (and are not usually accounted for in simulations), but
they can also add unnecessary transmission line effects.
Avoid ground and power loops. This has been one of the most
violated guidelines of PCB layout. Loops are excellent noise
transmitters and can be easily avoided. When using multiple layer
PCBs, the power and ground plane concept works well but only
when strictly adhered to (do not compromise the ground plane by
cutting a hole in it and running signals on the ground plane layer).
Keep the spacing around via holes to a minimum (but not so small
as to add capacitive effects).
Be aware of the three dimensional capacitive effects of multi-
layered PCBs.
Bypass (decouple) the power supplies of all chips as close to the
chip as possible. Use one decoupling capacitor per power supply
pair (VDD/VSS, VDDX/VSSX...). Two capacitors with a ratio of
about 100 sometimes offer better performances over a broader
Appendix: CGM Practical Aspects
Go to: www.freescale.com
Appendix: CGM Practical Aspects
Printed Circuit Board Guidelines
Technical Data
453