HD64F2378RVFQ33 Renesas Electronics America, HD64F2378RVFQ33 Datasheet - Page 1008

• Manufacturer Part Number: HD64F2378RVFQ33
• Description: IC H8S MCU FLASH 512K 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of HD64F2378RVFQ33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 97
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 6x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 21 Flash Memory (0.18-μm F-ZTAT Version)
(8)
The order for commands in the inquiry selection state is shown below.
1. A supported device inquiry (H'20) should be made to inquire about the supported devices.
2. The device should be selected from among those described by the returned information and set
3. A clock-mode inquiry (H'21) should be made to inquire about the supported clock modes.
4. The clock mode should be selected from among those described by the returned information
5. After selection of the device and clock mode, inquiries for other required information should
6. A new bit rate should be selected with the new bit-rate selection (H'3F) command, according
7. After selection of the device and clock mode, the information of the user boot MAT and user
8. After making inquiries and selecting a new bit rate, issue the transition to programming/erasing
Rev.7.00 Mar. 18, 2009 page 940 of 1136
REJ09B0109-0700
with a device-selection (H'10) command.
and set.
be made, such as the multiplication-ratio inquiry (H'22) or operating frequency inquiry (H'23),
which are needed for a new bit-rate selection.
to the returned information on multiplication ratios and operating frequencies.
MAT should be made to inquire about the user boot MATs information inquiry (H'24), user
MATs information inquiry (H'25), erased block information inquiry (H'26), and programming
unit inquiry (H'27).
state command (H'40). The boot program will then enter the programming/erasing state.
Command Order