LAN9303-ABZJ SMSC, LAN9303-ABZJ Datasheet - Page 41

• Manufacturer Part Number: LAN9303-ABZJ
• Description: IC ETHER SW 3PORT 16BIT 56QFN
• Manufacturer: SMSC

Specifications of LAN9303-ABZJ

• Controller Type: Ethernet Switch Controller
• Interface: SMBus (2-Wire/I²C)
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Supply: 190mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 56-QFN
• Product: Ethernet Switches
• Standard Supported: Yes
• Data Rate: 10 Mbps/100 Mbps
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 3 V
• Supply Current (max): 0.19 A (Typ)
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• For Use With: 638-1095 - EVALUATION BOARD FOR LAN9303
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 638-1082

Small Form Factor Three Port 10/100 Managed Ethernet Switch with Single MII/RMII/Turbo MII
Datasheet
SMSC LAN9303/LAN9303i
3.3
BUFFER TYPE
OCLK
OD12
OS12
ICLK
OD8
O12
O16
AIO
O8
PU
PD
IS
AI
P
Buffer Types
Schmitt-triggered Input
Output with 8mA sink and 8mA source
Open-drain output with 8mA sink
Output with 12mA sink and 12mA source
Open-drain output with 12mA sink
Open-source output with 12 mA source
Output with 16mA sink and 16mA source
50uA (typical) internal pull-up. Unless otherwise noted in the pin description, internal pull-
ups are always enabled.
Note:
50uA (typical) internal pull-down. Unless otherwise noted in the pin description, internal
pull-downs are always enabled.
Note:
Analog input
Analog bi-directional
Crystal oscillator input pin
Crystal oscillator output pin
Power pin
internal resistors to drive signals external to the device. When connected to a load
that must be pulled high, an external resistor must be added.
on internal resistors to drive signals external to the device. When connected to a
load that must be pulled low, an external resistor must be added.
Internal pull-up resistors prevent unconnected inputs from floating. Do not rely on
Internal pull-down resistors prevent unconnected inputs from floating. Do not rely
Table 3.11 Buffer Types
DATASHEET
41
DESCRIPTION
Revision 1.4 (07-07-10)