peb2256 Infineon Technologies Corporation, peb2256 Datasheet - Page 412

• Manufacturer Part Number: peb2256
• Description: E1/t1/j1 Framer And Line Interface Component For Long And Short Haul Applications
• Manufacturer: Infineon Technologies Corporation

LFA
RRA
LMFA
FSRF
Data Sheet
Loss of Frame Alignment
The flag is set if pulseframe synchronization has been lost. The
conditions are specified by bit FMR4.SSC(1:0). Setting this bit causes
an interrupt (ISR2.LFA).
The flag is cleared when synchronization has been regained.
Additionally interrupt status ISR2.FAR is set with clearing this bit.
Receive Remote Alarm (Yellow Alarm)
The flag is set after detecting remote alarm (yellow alarm). Conditions
for setting/resetting are defined by bit RC0.RRAM.
With the rising edge of this bit an interrupt status bit ISR2.RA is set.
With the falling edge of this bit an interrupt status bit ISR2.RAR is set.
The bit is set during alarm simulation and reset if FRS2.ESC = 0, 3,
4,5,7 and no alarm condition exists.
Loss Of Multiframe Alignment
Set in F12 or F72 format when 2 out of 4 (or 5 or 6) multiframe
alignment patterns are incorrect.
Additionally the interrupt status bit ISR2.LMFA is set.
Cleared after multiframe synchronization has been regained. With the
falling edge of this bit an interrupt status bit ISR2.MFAR is generated.
Frame Search Restart Flag
Toggles when no framing candidate (pulse framing or multiframing) is
found and a new frame search is started.
412
T1/J1 Registers
FALC56 V1.2
PEB 2256
2002-08-27