PIC18F258 MICROCHIP [Microchip Technology], PIC18F258 Datasheet - Page 138

• Manufacturer Part Number: PIC18F258
• Description: High Performance, 28/40-Pin Enhanced FLASH Microcontrollers with CAN
• Manufacturer: MICROCHIP [Microchip Technology]

PIC18FXX8
FIGURE 16-6:
16.5.3.1
In the Full-Bridge Output mode, the EPWM1M1 bit in
the ECCP1CON register allows user to control the
Forward/Reverse direction. When the application firm-
ware changes this direction control bit, the ECCP1
module will assume the new direction on the next PWM
cycle. The current PWM cycle still continues, however,
the non-modulated outputs, P1A and P1C signals, will
transition to the new direction T
earlier (for T2CKRS<1:0> = 00, 01 or 1x, respectively),
before the end of the period. During this transition
cycle, the modulated outputs, P1B and P1D, will go to
the inactive state (Figure 16-7).
Note that in the Full-Bridge Output mode, the ECCP
module does not provide any deadband delay. In gen-
eral, since only one output is modulated at all times,
deadband delay is not required. However, there is a sit-
uation where a deadband delay might be required. This
situation occurs when all of the following conditions are
true:
1.
2.
DS41159B-page 136
The direction of the PWM output changes when
the duty cycle of the output is at or near 100%.
The turn off time of the power switch, including
the power device and driver circuit, is greater
than turn on time.
PIC18F448/458
Direction Change in Full-Bridge
Mode
P1D
P1C
P1B
P1A
EXAMPLE OF FULL-BRIDGE APPLICATION
OSC
, 4 T
OSC
or 16 T
FET
Driver
FET
Driver
OSC
Preliminary
QD
QC
Figure 16-8 shows an example where the PWM direc-
tion changes from forward to reverse, at a near 100%
duty cycle. At time t1, the output P1A and P1D become
inactive, while output P1C becomes active. In this
example, since the turn off time of the power devices is
longer than the turn on time, a shoot-through current
flows through power devices QB and QD (see
Figure 16-6) for the duration of ‘t’. The same phenom-
enon will occur to power devices QA and QC for PWM
direction change from reverse to forward.
If changing PWM direction at high duty cycle is required
for an application, one of the following requirements
must be met:
1.
2.
Avoid changing PWM output direction at or near
100% duty cycle.
Use switch drivers that compensate the slow
turn off of the power devices. The total turn off
time (t
must be less than the turn on time (t
+
Load
V+
V-
off
) of the power device and the driver
-
QB
QA
 2002 Microchip Technology Inc.
FET
Driver
FET
Driver
on
).