OM13013,598 NXP Semiconductors, OM13013,598 Datasheet - Page 156

• Manufacturer Part Number: OM13013,598
• Description: BOARD DEMO IAR LPC1227 JLINKLITE
• Manufacturer: NXP Semiconductors
• Series: -r

Specifications of OM13013,598

• Design Resources: LPC122x-SK Brd Schematic
• Processor To Be Evaluated: LPC1227
• Processor Series: LPC122x
• Data Bus Width: 32 bit
• Interface Type: UART, SSP, SPI, I2C
• Cpu Core: ARM Cortex-M0
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 3 V to 3.6 V
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 568-6885

NXP Semiconductors
UM10441
User manual
9.5.16 UART RS-485 Address Match register
9.5.17 UART1 RS-485 Delay value register
Table 156. UART RS485 Control register (RS485CTRL - address 0x4000 804C) bit description
The RS485ADRMATCH register contains the address match value for RS-485/EIA-485
mode.
Table 157. UART RS-485 Address Match register (RS485ADRMATCH - address 0x4000 8050)
The user may program the 8-bit RS485DLY register with a delay between the last stop bit
leaving the TXFIFO and the de-assertion of RTS (or DTR). This delay time is in periods of
the baud clock. Any delay time from 0 to 255 bit times may be programmed.
Table 158. UART RS-485 Delay value register (RS485DLY - address 0x4000 8054) bit
Bit
3
4
5
31:6 -
Bit
7:0
31:8
Bit
7:0
31:8
Symbol
SEL
DCTRL
OINV
Symbol
DLY
-
Symbol
ADRMATCH
-
…continued
bit description
description
All information provided in this document is subject to legal disclaimers.
Description
Contains the direction control (RTS or DTR) delay value. This
register works in conjunction with an 8-bit counter.
Reserved, user software should not write ones to reserved bits.
The value read from a reserved bit is not defined.
Value
0
1
0
1
0
1
-
Rev. 1 — 15 February 2011
Description
Contains the address match value.
Reserved
Description
Select direction control pin
If direction control is enabled (bit DCTRL = 1), pin
RTS is used for direction control.
If direction control is enabled (bit DCTRL = 1), pin
DTR is used for direction control.
Auto direction control enable.
Disable Auto Direction Control.
Enable Auto Direction Control.
Polarity control. This bit reverses the polarity of
the direction control signal on the RTS (or DTR)
pin.
The direction control pin will be driven to logic 0
when the transmitter has data to be sent. It will be
driven to logic 1 after the last bit of data has been
transmitted.
The direction control pin will be driven to logic 1
when the transmitter has data to be sent. It will be
driven to logic 0 after the last bit of data has been
transmitted.
Reserved, user software should not write ones to
reserved bits. The value read from a reserved bit
is not defined.
Chapter 9: LPC122x UART0 with modem control
UM10441
© NXP B.V. 2011. All rights reserved.
Reset value
0x00
-
Reset value
0x00
NA
Reset
value
0
0
0
NA
156 of 442