MCF5282CVM66 Freescale, MCF5282CVM66 Datasheet - Page 396

• Manufacturer Part Number: MCF5282CVM66
• Manufacturer: Freescale

Specifications of MCF5282CVM66

• Cpu Family: MCF528x
• Device Core: ColdFire
• Device Core Size: 32b
• Frequency (max): 66MHz
• Interface Type: CAN/I2C/QSPI/UART
• Total Internal Ram Size: 64KB
• # I/os (max): 150
• Number Of Timers - General Purpose: 12
• Operating Supply Voltage (typ): 3.3V
• On-chip Adc: 8-chx10-bit
• Instruction Set Architecture: RISC
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 256
• Package Type: MA-BGA
• Program Memory Type: Flash
• Program Memory Size: 512KB
• Lead Free Status / RoHS Status: Compliant

DMA Timers (DTIM0–DTIM3)
21-4
ORRI
Field
15–8
FRR
CLK
RST
7–6
2–1
OM
CE
PS
5
4
3
0
Prescaler value. Divides the clock input (internal bus clock/(16 or 1) or clock on DTINn)
0x00 1
...
0xFF 256
Capture edge.
00 Disable capture event output. Timer in reference mode.
01 Capture on rising edge only
10 Capture on falling edge only
11 Capture on any edge
Output mode.
0 Active-low pulse for one internal bus clock cycle (12.5-ns resolution at 80 MHz)
1 Toggle output.
Output reference request, interrupt enable. If ORRI is set when DTERn[REF] is set, a DMA request or an interrupt
occurs, depending on the value of DTXMRn[DMAEN] (DMA request if set, interrupt if cleared).
0 Disable DMA request or interrupt for reference reached (does not affect DMA request or interrupt on capture
1 Enable DMA request or interrupt upon reaching the reference value.
Free run/restart
0 Free run. Timer count continues incrementing after reaching the reference value.
1 Restart. Timer count is reset immediately after reaching the reference value.
Input clock source for the timer. Avoid setting CLK when RST is already set. Doing so causes CLK to zero (stop
counting).
00 Stop count
01 Internal bus clock divided by 1
10 Internal bus clock divided by 16. This clock source is not synchronized with the timer; therefore, successive
11 DTINn pin (falling edge)
Reset timer. Performs a software timer reset similar to an external reset, although other register values can be written
while RST is cleared. A transition of RST from 1 to 0 resets register values. The timer counter is not clocked unless
the timer is enabled.
0 Reset timer (software reset)
1 Enable timer
function).
time-outs may vary slightly.
Table 21-2. DTMRn Field Descriptions
Description
Freescale Semiconductor