ST7LITE49K2 STMicroelectronics, ST7LITE49K2 Datasheet - Page 171

• Manufacturer Part Number: ST7LITE49K2
• Description: 8-bit MCU
• Manufacturer: STMicroelectronics

Specifications of ST7LITE49K2

• 8 Kbytes Single Voltage Extended Flash (xflash) Program Memory With Read-out Protection In-circuit Programming And In-application Programming (icp And Iap) Endurance: 10K write/erase cycles guaranteed Data retention
• 256 Bytes Data Eeprom With Read-out Protection. 300k Write/erase Cycles Guaranteed, Data Retention: 20 years at 55 °C.
• Clock Sources: Internal trimmable 8 MHz RC oscillator, auto-wakeup internal low power - low frequency oscillator, crystal/ceramic resonator or external clock
• Five Power Saving Modes: Halt, Active-halt, Auto-wakeup from Halt, Wait and Slow

ST7LITE49K2
11.7
11.7.1
11.7.2
11.7.3
10-bit A/D converter (ADC)
Introduction
The on-chip analog to digital converter (ADC) peripheral is a 10-bit, successive
approximation converter with internal sample and hold circuitry. This peripheral has up to 10
multiplexed analog input channels (refer to device pin out description) that allow the
peripheral to convert the analog voltage levels from up to 10 different sources.
The result of the conversion is stored in a 10-bit Data register. The A/D converter is
controlled through a Control/Status register.
Main features
●
●
●
●
●
●
The block diagram is shown in
Functional description
Analog power supply
V
device pin out description) they are internally connected to the V
Conversion accuracy may therefore be impacted by voltage drops and noise in the event of
heavily loaded or badly decoupled power supply lines.
DDA
10-bit conversion
Up to 10 channels with multiplexed input
Linear successive approximation
Data register (DR) which contains the results
Conversion complete status flag
On/off bit (to reduce consumption)
and V
SSA
are the high and low level reference voltage pins. In some devices (refer to
Figure
80.
DD
and V
On-chip peripherals
SS
pins.
171/245