ST7LITE49K2 STMicroelectronics, ST7LITE49K2 Datasheet - Page 63

• Manufacturer Part Number: ST7LITE49K2
• Description: 8-bit MCU
• Manufacturer: STMicroelectronics

Specifications of ST7LITE49K2

• 8 Kbytes Single Voltage Extended Flash (xflash) Program Memory With Read-out Protection In-circuit Programming And In-application Programming (icp And Iap) Endurance: 10K write/erase cycles guaranteed Data retention
• 256 Bytes Data Eeprom With Read-out Protection. 300k Write/erase Cycles Guaranteed, Data Retention: 20 years at 55 °C.
• Clock Sources: Internal trimmable 8 MHz RC oscillator, auto-wakeup internal low power - low frequency oscillator, crystal/ceramic resonator or external clock
• Five Power Saving Modes: Halt, Active-halt, Auto-wakeup from Halt, Wait and Slow

ST7LITE49K2
9
9.1
Power saving modes
Introduction
To give a large measure of flexibility to the application in terms of power consumption, four
main power saving modes are implemented in the ST7 (see
●
●
●
●
●
After a reset the normal operating mode is selected by default (Run mode). This mode
drives the device (CPU and embedded peripherals) by means of a master clock which is
based on the main oscillator frequency (f
From Run mode, the different power saving modes may be selected by setting the relevant
register bits or by calling the specific ST7 software instruction whose action depends on the
oscillator status.
Figure 24. Power saving mode transitions
Slow
Wait (and Slow-Wait)
Active-halt
Auto-wakeup from Halt (AWUFH)
Halt
POWER CONSUMPTION
Active Halt
Slow Wait
OSC
Slow
Wait
Run
Halt
).
Low
High
Figure
24):
Power saving modes
63/245