R0K561622S000BE Renesas Electronics America, R0K561622S000BE Datasheet - Page 883

• Manufacturer Part Number: R0K561622S000BE
• Description: KIT STARTER FOR H8SX/1622
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K561622S000BE

• Contents: Board, Cables, CD, Debugger, Power Supply
• Silicon Manufacturer: Renesas
• Features: Coding And Debugging, E10A Emulator, RS232 Serial Connection
• Kit Contents: Board
• Silicon Family Name: H8SX/1622F
• Silicon Core Number: R5F61622N50LGV
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: H8SX/1622
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

(7)
The order for commands in the inquiry selection state is shown below.
1. A supported device inquiry (H'20) should be made to inquire about the supported devices.
2. The device should be selected from among those described by the returned information and set
3. A clock-mode inquiry (H'21) should be made to inquire about the supported clock modes.
4. The clock mode should be selected from among those described by the returned information
5. After selection of the device and clock mode, inquiries for other required information should
6. A new bit rate should be selected with the new bit-rate selection (H'3F) command, according
7. After selection of the device and clock mode, the information of the user boot MAT and user
8. After making inquiries and selecting a new bit rate, issue the transition to
with a device-selection (H'10) command.
and set.
be made, such as the multiplication-ratio inquiry (H'22) or operating frequency inquiry (H'23),
which are needed for a new bit-rate selection.
to the returned information on multiplication ratios and operating frequencies.
MAT should be made to inquire about the user boot MATs information inquiry (H'24), user
MATs information inquiry (H'25), erased block information inquiry (H'26), and programming
unit inquiry (H'27).
programming/erasing state command (H'40). The boot program will then enter the
programming/erasing state.
Command Order
Rev. 2.00 Sep. 16, 2009 Page 853 of 1036
Section 22 Flash Memory
REJ09B0414-0200