XW2Z-070T-1 Omron, XW2Z-070T-1 Datasheet - Page 110

• Manufacturer Part Number: XW2Z-070T-1
• Description: Special Nissan
• Manufacturer: Omron
• Series: XW2Zr
• Type: DB09r

Specifications of XW2Z-070T-1

• 1st Connector: Plug, Male Pins
• 2nd Connector: Plug, Male Pins
• Number Of Positions: 9
• Length: 2.3' (701.0mm)
• Color: Beige, Individual (Round)
• Usage: Communication
• Contact Finish: Gold
• Contact Finish Thickness: 15µin (0.38µm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Shielding: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z070T1

7-1
7-1-1
7-1-2
7-1-3
7-2
Allocating Read/Write
Areas with the PC Setup
98
Initial Settings
Initial Settings
Remote I/O Communications
Attaching Status Information
Setting the Node Number
Setting the Communications Speed
Set the DeviceNet node number with the rotary switches on the CPM2B-S
CPU Board. The allowed setting range is 00 to 63; node number settings 64 to
99 are not allowed. The rotary switch settings are read when the Unit’s power
is turned ON.
Set the DeviceNet communications speed with DIP switch 2 on the front of the
Unit. The DIP switch settings are read when the Unit’s power is turned ON.
It is possible to enable and disable the attachment of the CPM2B-S status
information in transmissions from the CPM2B-S to the Master Unit.
The status attachment is set in DM 6605 of the PC Setup, as shown in the fol-
lowing table. The initial setting is 0 (attach status information); change this
setting to 1 to disable attachment of status information. Refer to 7-4 Status
Information for details on the status information.
Allocate the DeviceNet read and write areas to specify what part of the PC’s
data area will be used to read and write data from the DeviceNet Master Unit.
Specify the PC data area, starting word address, and number of bytes. Up to
64 bytes can be allocated for DeviceNet remote I/O.
Switch the CPM2B-S to PROGRAM mode and use a Programming Device,
such as a Programming Console or Support Software, to make the following
settings in DM 6605 to DM 6609 of the PC Setup. The settings in these words
are read only when the CPM2B-S is turned ON, so the PC’s power must be
turned OFF and then ON again to make changes effective.
OFF
ON
OFF
ON
DM 6605
DIP switch 2 settings
Word
Pin 1
04 to 07
OFF
OFF
ON
ON
Bits
Pin 2
Sets whether CPM2B-S status is transmitted to
the DeviceNet Master.
0 (Hex): Attach status ahead of data.
1 (Hex): Do not attach status ahead of data.
125 kbps
250 kbps
500 kbps
Not used.
communications speed
DeviceNet
X10
Function
X1
ON
500 m max.
250 m max.
100 m max.
---
communications distance
Maximum total
Section 7-1
0
(Attach
status.)
Default