XW2Z-070T-1 Omron, XW2Z-070T-1 Datasheet - Page 120

• Manufacturer Part Number: XW2Z-070T-1
• Description: Special Nissan
• Manufacturer: Omron
• Series: XW2Zr
• Type: DB09r

Specifications of XW2Z-070T-1

• 1st Connector: Plug, Male Pins
• 2nd Connector: Plug, Male Pins
• Number Of Positions: 9
• Length: 2.3' (701.0mm)
• Color: Beige, Individual (Round)
• Usage: Communication
• Contact Finish: Gold
• Contact Finish Thickness: 15µin (0.38µm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Shielding: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z070T1

ERROR RESPONSE
7-3-3
CS1, CVM1, and CV-series PCs: Reading Data with CMND(194)
Example Network
Conditions
108
Explicit Message Communications
Examples of DeviceNet Explicit Messages
The CPM2B-S returns an error response when there is an error in the explicit
message command sent from the DeviceNet Master.
Response Format
Parameters
Number of bytes received (response)
Indicates the number of bytes of data (in hexadecimal) from the “source node
number.”
Source node number (response)
Indicates the node number (in hexadecimal) of the CPM2B-S that returned
the response.
General error code (response)
Indicates the nature of the error with one of the 1-byte (2-digit hexadecimal)
error codes listed in the following table.
Additional error code (response)
Always FF (Hex).
This example shows the instruction operands and results when 20 words of
data (IR 010 to IR029) in a Slave are read through a Master mounted in a
CS1, CVM1 or CV-series PC.
For details on explicit messages, refer to the CS1 Series DeviceNet Unit
Operation Manual (W380) for CS1-series PCs, and refer to the DeviceNet
(CompoBus/D) Operation Manual (W267) for CVM1 and CV-series PCs. For
details on CMND(194), refer to the CS1 Series Programmable Controllers
Operation Manual (W339) for CS1-series PCs, and refer to the CVM1/CV
Series CV500/CV100/CV2000/CVM1 Programmable Controllers Operation
Manual: Ladder Diagrams (W202) for CVM1 and CV-series PCs.
Master’s node number:
Slave’s network address: 1
Slave’s node number:
08 (Hex) Service not supported
15 (Hex) Too much data
13 (Hex) Not enough data
20 (Hex) Invalid parameter
11 (Hex) Reply data too large
16 (Hex) Object does not exist
Code
Error name
Number of bytes received
63
2
Source node number
General error code
The service code was invalid.
There was too much data. (For example, the
amount of write data exceeded the data area
boundary.)
There was too little data. (For example, an odd
number of bytes of write data were used in a
WRITE WORD DATA command.)
The starting word address was invalid.
The data area boundary was exceeded in a
DATA READ command.
The class ID or instance ID was invalid.
Additional error code
(Always FF)
Meaning
Section 7-3