XW2Z-070T-1 Omron, XW2Z-070T-1 Datasheet - Page 47

• Manufacturer Part Number: XW2Z-070T-1
• Description: Special Nissan
• Manufacturer: Omron
• Series: XW2Zr
• Type: DB09r

Specifications of XW2Z-070T-1

• 1st Connector: Plug, Male Pins
• 2nd Connector: Plug, Male Pins
• Number Of Positions: 9
• Length: 2.3' (701.0mm)
• Color: Beige, Individual (Round)
• Usage: Communication
• Contact Finish: Gold
• Contact Finish Thickness: 15µin (0.38µm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Shielding: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z070T1

Selecting an Installation Site
3-2
3-2-1
3-2-2
Overheating
Selecting an Installation Site
Installation Site Conditions
Panel/Cabinet Installation
! C a u t i o n
Note Do not install the CPM2B-S under any of the following conditions.
Note Provide proper shielding when installing in the following locations:
The CPM2B-S is resistant to harsh conditions and highly reliable, but install-
ing the PC in a favorable site will maximize its reliability and operating lifetime.
Be sure to install the CPM2B-S correctly, as outlined in this manual. Failure to
do so may result in Board malfunction.
Be sure that the conditions at the installation site conform to the CPM2B-S’s
general specifications. Refer to 2-1-1 General Specifications for details.
Consider PC operation, maintenance, and surrounding conditions when
installing the CPM2B-S in a panel or cabinet.
The ambient operating temperature range for the CPM2B-S is 0°C to 55°C.
Be sure that there is adequate ventilation for cooling.
• Locations subject to direct sunlight.
• Locations subject to an ambient temperature below 0°C or over 55°C.
• Locations subject to an ambient humidity below 10% or over 90%.
• Locations subject to condensation as the result of severe changes in tem-
• Locations subject to corrosive or flammable gases.
• Locations subject to dust (especially iron dust) or salts.
• Locations subject to shock or vibration.
• Locations subject to exposure to water, oil, or chemicals.
• Locations subject to static electricity or other sources of noise.
• Locations subject to strong electromagnetic fields.
• Locations subject to possible exposure to radiation.
• Locations near to power supply lines.
• Allow enough space for air circulation.
• Do not install the CPM2B-S above equipment that generates a large
• Install a cooling fan or system when the ambient temperature exceeds
perature.
amount of heat, such as heaters, transformers, or large resistors.
55°C.
Air vent
Control panel
CPM2B-S
Fan
Section 3-2
35