XW2Z-070T-1 Omron, XW2Z-070T-1 Datasheet - Page 51

• Manufacturer Part Number: XW2Z-070T-1
• Description: Special Nissan
• Manufacturer: Omron
• Series: XW2Zr
• Type: DB09r

Specifications of XW2Z-070T-1

• 1st Connector: Plug, Male Pins
• 2nd Connector: Plug, Male Pins
• Number Of Positions: 9
• Length: 2.3' (701.0mm)
• Color: Beige, Individual (Round)
• Usage: Communication
• Contact Finish: Gold
• Contact Finish Thickness: 15µin (0.38µm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Shielding: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z070T1

Wiring and Connections
Example Installations
3-5
General Precautions for Wiring
I/O Line Noise
Wiring and Connections
! C a u t i o n
Note
1. When attaching the Mounting Bracket, use M4 screws and tighten to a
2. The CPM2B-S can be installed without a CPM2B-ATT01 Mounting Brack-
3. Installing the CPM2B-S horizontally or with its narrow edge down affects
This section provides basic information on power supply wiring and I/O wiring.
Cover the CPM2B-S Boards with plastic or use some other method to prevent
strands of wire from getting on the Board or inside the Board’s components
during wiring. Wire strands may short circuit the Board’s components.
Do not run CPM2B-S I/O lines in the same duct or conduit as power lines.
Hanging Ducts
Leave at least 300 mm between the power cables and the I/O or control wir-
ing, as shown in the following diagram.
torque of 1.2 N•m.
et. When a Mounting Bracket is not being used, prepare the panel as
shown in the following diagram.
Use M3 screws to attach to the panel and tighten to a torque of 0.5 N•m.
cooling and limits the number of inputs that can be ON simultaneously at
high temperatures. Refer to page 26 for details.
Control cables and
CPM2B-S power lines
CPM2B-S I/O lines
Screw and nut
installation
Four, M3
Power cables
Mounting Bracket
164 mm
Screw and tapped
panel installation
300 mm min.
300 mm min.
Section 3-5
39