XW2Z-070T-1 Omron, XW2Z-070T-1 Datasheet - Page 85

• Manufacturer Part Number: XW2Z-070T-1
• Description: Special Nissan
• Manufacturer: Omron
• Series: XW2Zr
• Type: DB09r

Specifications of XW2Z-070T-1

• 1st Connector: Plug, Male Pins
• 2nd Connector: Plug, Male Pins
• Number Of Positions: 9
• Length: 2.3' (701.0mm)
• Color: Beige, Individual (Round)
• Usage: Communication
• Contact Finish: Gold
• Contact Finish Thickness: 15µin (0.38µm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Shielding: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z070T1

PC Setup
4-6
4-6-1
Changing PC Setup
Settings
CPU Unit Access of PC
Setup Settings
PC Setup Errors
PC Setup
Overview
Note
1. The same data can be read immediately with PRV(62).
2. The units for the maximum and current cycle times are determined by the
The PC Setup (DM 6600 to DM 6655) contains various settings that control
PC operation. Changes to the PC Setup are saved when the CPM2B-S is
turned OFF, program execution is started, or program execution is stopped.
Always perform one of the following operations after changing the PC Setup:
The PC Setup (DM 6600 to DM 6655) can be edited from a Programming
Device. The settings in DM 6600 to DM 6644 can be changed only when the
PC is in PROGRAM mode. The settings in DM 6645 to DM 6655 can be
changed when the PC is in PROGRAM mode or MONITOR mode, although
the PC’s cycle time will be quite long when the settings are changed in MONI-
TOR mode.
The CPM2B-S CPU Unit reads parts of the PC Setup at different points of PC
operation. The CPU Unit timing is as follows:
If there is an error in the PC Setup settings, a non-fatal error (error code 9B)
will be generated when the CPU Unit accesses that part of the PC Setup. The
PC Setup Error Flags (AR 1300 to AR 1302) indicate the part of the PC Setup
where the error is located. The default setting (usually 0000) is used instead
of the incorrect setting.
• Switch the CPM2B-S to MONITOR mode or RUN mode.
• Turn the CPM2B-S OFF and then ON again.
setting in bits 08 to 15 of DM 6618. A setting of 00 specifies 0.1-ms units,
01 specifies 0.1-ms units, 02 specifies 1-ms units, and 03 specifies 10-ms
units.
DM 6600 to DM 6614: Read once when the PC is turned ON.
DM 6615 to DM 6644: Read once at the start of program execution.
DM 6645 to DM 6655: Read regularly while the PC is ON.
Section 4-6
73