EP1S10F780I6N Altera, EP1S10F780I6N Datasheet - Page 788

• Manufacturer Part Number: EP1S10F780I6N
• Description: IC STRATIX FPGA 10K LE 780-FBGA
• Manufacturer: Altera
• Series: Stratix®r

Specifications of EP1S10F780I6N

• Number Of Logic Elements/cells: 10570
• Number Of Labs/clbs: 1057
• Total Ram Bits: 920448
• Number Of I /o: 426
• Voltage - Supply: 1.425 V ~ 1.575 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 780-FBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of Gates: -

Remote Configuration Operation
12–10
Stratix Device Handbook, Volume 2
RU_shftnhld
RU_captnupdt
RU_Din
RU_Dout
Table 12–3. User Configuration Signals To/From Device Core (Part 2 of 2)
Signal Name
Output from the core to the
remote update block
Output from the core to the
remote update block
Output from the core to the
remote update block
Input to the core from the remote
update block
To/From Device Core
All of the seven device core signals (see
remote and local configuration for both factory and application
configuration, except RU_Timer and RU_captnupdt.
Table 12–4
(POR).
The difference between local configuration and remote configuration is
how the control register is updated during a re-configuration and which
core signals are enabled.
specify the content of control register upon power-on reset
If its value is “1”, the remote configuration shift register
shifts data on the rising edge of
“0” and
the update register. If its value is “0”, and
RU_captnupdt
status register and either the control or update register
(depending on whether the configuration is factory or
application).
When
RU_shftnhld
the remote configuration shift register should be written
with the content of the status register and either the
update register (in a factory configuration) or the control
register (in an application configuration). This shift
register is loaded on the rising edge of
RU_captnupdt
value”0”, the system specifies that the remote
configuration update register should be written with the
content of the shift register in a factory configuration. The
update register is loaded on the rising edge of
This pin is enabled only for factory configuration in
remote configuration mode (it is disabled for the
application configuration in remote configuration or for
local configuration modes). If
“1”,
Data to be written into the remote configuration shift
register on the rising edge of
shift register,
Output of the remote configuration shift register to be
read by core logic. New data arrives on each rising edge
of
RU_Clk
RU_captnupdt
RU_captnupdt
RU_captnupdt
.
RU_shftnhld
is at value”0”, the system specifies that
is at value “0” and
is “1”, the shift register captures the
Figure
has no function.
Description
is at value “1” and
is “0”, the shift register updates
12–6), are enabled for both
RU_shftnhld
RU_Clk
must be asserted.
RU_Clk
RU_shftnhld
Altera Corporation
Figure 12–7
. To load into the
RU_Clk
September 2004
. It its value is
is at value
RU_Clk
. When
and
is at
.