pef2256e Infineon Technologies Corporation, pef2256e Datasheet - Page 78

no-image

pef2256e

Manufacturer Part Number
pef2256e
Description
E1/t1/j1 Framer And Line Interface Component For Long- And Short-haul Applications
Manufacturer
Infineon Technologies Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
pef2256eV2.1ES
Manufacturer:
HARRIS
Quantity:
101
Part Number:
pef2256eV2.2
Manufacturer:
INFINEON
Quantity:
513
Part Number:
pef2256eV2.2
Manufacturer:
LANTIQ
Quantity:
8 000
framing is performed, i.e. without flag recognition, CRC checking or bit stuffing. This
allows user specific protocol variations.
4.1.15.2 Support of Signaling System #7
The HDLC controller of channel 1 supports the signaling system #7 (SS7) which is
described in ITU-Q.703. The following description assumes, that the reader is familiar
with the SS7 protocol definition.
SS7 support must be activated by setting the MODE register. The SS7 protocol is
supported by the following hardware features in receive mode:
In order to reduce the microprocessor load, fill In signaling units (FISUs) are processed
automatically. By examining the length indicator of a received signal unit the FALC
decides whether a FISU has been received. Consecutively received FISUs are
compared and optionally not stored in the receive FIFO (RFIFO, 2× 32 bytes), if the
contents is equal to the previous one. The same applies to link status signaling units, if
bit CCR5.CSF is set. The different types of signaling units as message signaling unit
(MSU), link status signaling unit (LSSU) and fill in signaling units (FISU) are indicated in
the RSIS register, which is automatically added to the RFIFO with each received
signaling unit. The complete signaling unit except start and end flags is stored in the
receive FIFO. The functions of bits CCR1.RCRC and CCR1.RADD are still valid in SS7
mode. Errored signaling units are handled automatically according to ITU-T Q.703 as
shown in
CMDR2.RSUC. The error threshold T can be selected to be 64 (default) or 32 by
setting/clearing bit CCR5.SUET. If the defined error limit is exceeded, an interrupt
(ISR1.SUEX) is generated, if not masked by IMR1.SUEX = 1.
Note: If SUEX is caused by an aborted/invalid frame, the interrupt will be issued
User’s Manual
Hardware Description
All Signaling Units (SU) are stored in the receive FIFO (RFIFO)
Detecting of flags from the incoming data stream
Bit stuffing (zero deletion)
Checking of seven or more consecutive ones in the receive data stream
Checking if the received Signaling Unit is a multiple of eight bits and at least six octets
including the opening flag
Calculation of the CRC16 checksum:
In receive direction the calculated checksum is compared to the received one; errors
are reported in register RSIS.
Checking if the signal information field of a received signaling unit consists of more
than 272 octets, in this case the current signaling unit is discarded.
regularly until a valid frame is received (e.g. a FISU).
Figure
23. SU counter (su) and errored SU counter (C
78
Functional Description E1
s
) are reset by setting
DS1.1, 2003-10-23
PEF 2256 H/E
FALC
®
®
56
56

Related parts for pef2256e