IPT-DSPBUILDER Altera, IPT-DSPBUILDER Datasheet - Page 102

• Manufacturer Part Number: IPT-DSPBUILDER
• Description: DSP BUILDER SOFTWARE
• Manufacturer: Altera
• Type: DSPr

Specifications of IPT-DSPBUILDER

• Function: DSP Builder
• License: Initial License
• Software Application: IP CORE, DSP BUILDER
• Core Architecture: FPGA
• Core Sub-architecture: Arria, Cyclone, Stratix
• Supported Families: Arria GX, Arria II GX, Cyclone, Stratix
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Not applicable / Not applicable

6–4
DSP Builder Standard Blockset User Guide
1. Select the Boards library from the Altera DSP Builder Blockset folder in the
2. Open the CycloneIIEP2C35 folder. Drag and drop the Cyclone II EP2C35 DSP
3. Drag and drop the SW2 and SW3 blocks close to the AND_Gate2 block in your
4. Drag and drop the SW4 and SW5 blocks close to the AND_Gate1 block in your
5. Drag and drop the LED0 block close to the OR_Gate block in your model. Connect
6. Select the Simulink Sources library. Drag and drop a Pulse Generator block
7. Drag and drop another Pulse Generator block near the SW4 and SW5 blocks
Figure 6–3. Switch Control Example with Board, Pulse Generator and Terminator Blocks
8. Use the Block Parameters dialog box to set the parameters
Simulink library browser.
Development Board configuration block into your model.
model. Connect these switch blocks to the AND_Gate2 inputs.
model. Connect these switch blocks to the AND_Gate1 inputs.
1
this block to the OR_Gate output.
near to the SW2 and SW3 blocks and connect it to these blocks.
and connect it to these blocks.
Figure 6–3
pulse generator blocks.
You can rotate the SW5 block to make the connection easier by right-clicking
the block and clicking Rotate Block on the Format menu.
shows your model.
Preliminary
Chapter 6: Performing SignalTap II Logic Analysis
© June 2010 Altera Corporation
(Table
SignalTap II Example Designs
6–1) for both