p2125vps20 Renesas Electronics Corporation., p2125vps20 Datasheet - Page 532

• Manufacturer Part Number: p2125vps20
• Description: 16-bit Single-chip Microcomputer H8s Family / H8s/2100 Series
• Manufacturer: Renesas Electronics Corporation.

Section 19 Flash Memory (0.18-µm F-ZTAT Version)
• The user MAT space is switched to the embedded program storage MAT.
• After the selection condition of the download program and the FTDAR address setting are
• The SCO bit in FPCS, FECS, and FCCS is cleared to 0.
• The return value is set to the DPFR parameter.
• After the embedded program storage MAT is returned to the user MAT space, execution
• In the download processing, the values of CPU general registers are retained.
• In the download processing, all interrupts are not accepted. However, interrupt requests except
• When the level-detection interrupt requests are to be held, interrupts must be input until the
• When hardware standby mode is entered during the download processing, normal download to
• Since a stack area of 128 bytes at the maximum is used, the stack area must be allocated before
• If a flash memory access by the DTC is requested during downloading, the operation cannot be
(d) Clear FKEY to H'00 for protection.
(e)
• Check the value of the DPFR parameter (single byte of start address of the download
• If the value of the DPFR parameter is the same as before downloading (e.g. H'FF), the address
• If the value of the DPFR parameter is different from before downloading, check the SS bit and
Rev. 1.00 Sep. 21, 2006 Page 494 of 658
REJ09B0310-0100
checked, the transfer processing to the on-chip RAM specified by FTDAR is executed.
returns to the user procedure program.
for NMI are held. Therefore, when execution returns to the user procedure program, the
interrupts will occur.
download is ended.
the on-chip RAM cannot be guaranteed. Therefore, download must be executed again.
setting the SCO bit to 1.
guaranteed. Therefore, access by the DTC must not occur.
destination specified by FTDAR). If the value is H'00, download has been performed
normally. If the value is not H'00, the source that caused download to fail can be investigated
by the description below.
setting of the download destination in FTDAR may be abnormal. In this case, confirm the
setting of the TDER bit in FTDAR.
FK bit in the DPFR parameter to ensure that the download program selection and FKEY
setting were normal, respectively.
Check the value of the DPFR parameter to confirm the download result.