HD6417144 RENESAS [Renesas Technology Corp], HD6417144 Datasheet - Page 431

• Manufacturer Part Number: HD6417144
• Description: 32-Bit RISC Microcomputer SuperHTM RISC engine Family/SH7144 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

12.4.3
The watchdog timer has a special function to clear software standby mode with an NMI interrupt
or IRQ0 to IRQ7 interrupts. When using software standby mode, set the WDT as described below.
Before Transition to Software Standby Mode: The TME bit in TCSR must be cleared to 0 to
stop the watchdog timer counter before entering software standby mode. The chip cannot enter
software standby mode while the TME bit is set to 1. Set bits CKS2 to CKS0 in TCSR so that the
counter overflow interval is equal to or longer than the oscillation settling time. See section 26.3,
AC Characteristics, for the oscillation settling time.
Recovery from Software Standby Mode: When an NMI signal or IRQ0 to IRQ7 signals are
received in software standby mode, the clock oscillator starts running and TCNT starts
incrementing at the rate selected by bits CKS2 to CKS0 before software standby mode was
entered. When TCNT overflows (changes from H'FF to H'00), the clock is presumed to be stable
and usable; clock signals are supplied to the entire chip and software standby mode ends.
For details on software standby mode, see section 24, Power-Down Modes.
12.4.4
In interval timer mode, when TCNT overflows, the OVF bit of TCSR is set to 1 and an interval
timer interrupt (ITI) is simultaneously requested. Figure 12.4 shows this timing.
Clearing Software Standby Mode
Timing of Setting Overflow Flag (OVF)
φ
TCNT
Overflow signal
(internal signal)
OVF
Figure 12.4 Timing of Setting OVF
H’FF
H’00
Rev.4.00 Mar. 27, 2008 Page 387 of 882
12. Watchdog Timer
REJ09B0108-0400