HD6477021X20V Renesas Electronics America, HD6477021X20V Datasheet - Page 85

• Manufacturer Part Number: HD6477021X20V
• Description: MCU 5V 32K PB-FREE 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7020r

Specifications of HD6477021X20V

• Core Processor: SH-1
• Core Size: 32-Bit
• Speed: 20MHz
• Connectivity: EBI/EMI, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 32
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: OTP
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -

5.2.1
NMI is the highest-priority interrupt (level 16) and is always accepted. Input at the NMI pin is
edge-sensed. Either the rising or falling edge can be selected by setting the NMI edge select bit
(NMIE) in the interrupt control register (ICR). NMI interrupt exception processing sets the
interrupt mask level bits (I3–I0) in the status register (SR) to level 15.
5.2.2
A user break interrupt occurs when a break condition is satisfied in the user break controller
(UBC). A user break interrupt has priority level 15. User break interrupt exception processing sets
the interrupt mask level bits (I3–I0) in the status register (SR) to level 15. For further details about
the user break interrupt, see section 6, User Break Controller.
5.2.3
IRQ interrupts are requested by input from pins IRQ0-IRQ7. IRQ sense select bits 0–7 (IRQ0S–
IRQ7S) in the interrupt control register (ICR) can select low-level sensing or falling-edge sensing
for each pin independently. Interrupt priority registers A and B (IPRA and IPRB) can select
priority levels from 0–15 for each pin. IRQ interrupt exception processing sets the interrupt mask
level bits (I3–I0) in the status register (SR) to the priority level value of the IRQ interrupt that was
accepted.
5.2.4
On-chip interrupts are interrupts generated by the following 5 on-chip peripheral modules:
•
•
•
•
•
A different interrupt vector is assigned to each interrupt source, so the exception service routine
does not have to decide which interrupt has occurred. Priority levels 0–15 can be assigned to
individual on-chip peripheral module in interrupt priority registers C–E (IPRC–IPRE). On-chip
interrupt exception processing sets the interrupt mask level bits (I3–I0) in the status register (SR)
to the priority level value of the on-chip interrupt that was accepted.
64 RENESAS
Direct memory access controller (DMAC)
16-bit integrated-timer pulse unit (ITU)
Serial communications interface (SCI)
Bus state controller (BSC)
Watchdog timer (WDT)
NMI Interrupts
User Break Interrupt
IRQ Interrupts
On-Chip Interrupts