FDC37C935-QS Standard Microsystems (SMSC), FDC37C935-QS Datasheet - Page 17

• Manufacturer Part Number: FDC37C935-QS
• Manufacturer: Standard Microsystems (SMSC)

Specifications of FDC37C935-QS

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DIGITAL OUTPUT REGISTER (DOR)
Address 3F2 READ/WRITE
The DOR controls the drive select and motor
enables of the disk interface outputs. It
BIT 0 and 1 DRIVE SELECT
These two bits are binary encoded for the four
drive selects DS0 -DS3, thereby allowing only
one drive to be selected at one time.
BIT 2 nRESET
A logic "0" written to this bit resets the Floppy
disk controller.
until a logic "1" is written to this bit.
software reset does not affect the DSR and CCR
registers, nor does it affect the other bits of the
DOR register.
required is 100ns, therefore toggling this bit by
consecutive writes to this register is a valid
method of issuing a software reset.
BIT 3 DMAEN
PC/AT and Model 30 Mode:
Writing this bit to logic "1" will enable the DRQ,
nDACK, TC and FINTR outputs. This bit being
a logic "0" will disable the nDACK and TC
inputs, and hold the DRQ and FINTR outputs in
a high impedance state. This bit is a logic "0"
after a reset and in these modes.
PS/2 Mode: In this mode the DRQ, nDACK, TC
and FINTR pins are always enabled. During a
reset, the DRQ, nDACK, TC, and FINTR pins
will remain enabled, but this bit will be cleared to
a logic "0".
RESET
COND.
The minimum reset duration
This reset will remain active
MOT
EN3
7
0
MOT
EN2
6
0
MOT
EN1
5
0
This
MOT
EN0
17
4
0
software reset bit. The contents of the DOR are
unaffected by a software reset. The DOR can
be written to at any time.
BIT 4 MOTOR ENABLE 0
This bit controls the MTR0 disk interface output.
go active.
BIT 5 MOTOR ENABLE 1
This bit controls the MTR1 disk interface output.
go active.
BIT 6 MOTOR ENABLE 2
This bit controls the MTR2 disk interface output.
go active.
BIT 7 MOTOR ENABLE 3
This bit controls the MTR3 disk interface output.
active.
A logic "1" in this bit will cause the output pin to
A logic "1" in this bit will cause the output pin to
A logic "1" in this bit will cause the output pin to
A logic "1" in this bit causes the output to go
DMAEN nRESE
3
0
Table 3 - Drive Activation Values
DRIVE
0
1
2
3
2
T
0
DRIVE
SEL1
1
0
DOR VALUE
DRIVE
1CH
2DH
4EH
8FH
SEL0
0
0