TMPM333FDFG Toshiba, TMPM333FDFG Datasheet - Page 422

• Manufacturer Part Number: TMPM333FDFG
• Description: Microcontrollers (MCU) MCU w/ ARM Cortex-M3 512K FLASH, 32K SRAM
• Manufacturer: Toshiba

Specifications of TMPM333FDFG

• Processor Series: TX03
• Core: ARM Cortex M3
• 3rd Party Development Tools: MDK-ARM, RL-ARM, ULINK2
• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 512K
• Rom Type: Flash
• Ram (kbytes): 32K
• Number Of Pins: 100
• Package: LQFP(14×14)
• Vcc: 3V
• Cpu Mhz: 40
• Ssp (ch) Spi: -
• I2c/sio (ch): 3
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: -
• Cs/wait Controller (ch): -
• Dma Controller: -
• 10-bit Da Converter: -
• 10-bit Ad Converter: 12
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 10
• Motor / Igbt Control: -
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: -
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit
• Lead Free Status / Rohs Status: Details

15.2
Operation Mode
15.2.10.7
an echo-back of the command code, the boot program verifies the contents of the 12-byte password area within
the flash memory. The following table shows the password area of each product.
as shown in Figure 15-7. In this case, the boot program returns an error acknowledge (0x11) in response to
the checksum byte (the 17th byte), regardless of whether the password sequence sent from the controller is
all 0xFFs.
in the flash memory. All of the 12 bytes must match to pass the password verification. Otherwise, a password
error occurs, which causes the boot program to reply an error acknowledge in response to the checksum byte
(the 17th byte).
The RAM Transfer command (0x10) causes the boot program to perform password verification. Following
If all these address locations contain the same bytes of data other than 0xFF, a password area error occurs
The password sequence received from the controller (5th to 16th bytes) is compared to the password stored
The password verification is performed even if the security function is enabled.
Note:If a password is set to 0xFF (erased data area), it is difficult to protect data securely due to an
Password
Figure 15-6 Serial Operation Mode Determination Flowchart
easy-to-guess password. Even if Single Boot mode is not used, it is recommended to set a
unique value as a password.
TMPM333FWFG
TMPM333FDFG
TMPM333FYFG
Product name
tCD ← tAD
UART mode
AB
Start
>
tCD?
tAC
Page 402
0x3F87_FF04 to 0x3F87_FF0F
0x3F81_FF04 to 0x3F81_FF0F
YES
Area
I/O interface mode
TMPM333FDFG/FYFG/FWFG