TMPM363F10FG Toshiba, TMPM363F10FG Datasheet - Page 490

• Manufacturer Part Number: TMPM363F10FG
• Manufacturer: Toshiba

Specifications of TMPM363F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 100
• Package: LQFP(14x14)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 4
• Uart/sio (ch): 5
• Usb: Host
• Can: 1
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: 8
• 10-bit Ad Converter: 8
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

15.4
Operations
(3)
(4)
(5)
Data sampring timing that specification recommends
by the unit of 1/fs from the minimum value (67/fs, approx. 2.045ms) or the maximum value (90/fs ap-
prox. 2.747ms).
start bit. The received data is discarded.
of 2/fs.
not as an ACK response to the data block when destination address corresponds with the address
set in the logical address register.
CACKDIS>.
(ACK bit: logical "0"). "No" indicates that CEC does not output "0" as a response to the ACK sig-
nal from a transmission device (ACK bit: logical "1").
0 ms
Configure CECRCR1<CECMIN> and <CECMAX> bits to detect a cycle error.
A cycle error can be detected from each sampling clock cycle between the ranges −4/fs to +3/fs
Detecting an error during data reception causes an error interrupt, and CEC waits for the next
Configure the CECRCR1 <CECDAT> bit for the point of determining the data as "0" or "1".
Base time is 34/fs (approx.1.038ms) from the start point and also configurable ±6/fs by the unit
Configuring the CECRCR1 <CECACKDIS> bit enables you to specify if logical "0" is sent or
Logical "0" issent to the header block as an ACK response regardless of the bit setting of <CE-
The following lists the ACK responses.
"Yes" indicates that CEC outputs "0" as a response to the ACK signal from a transmission device
Cycle error
Point of Determining Data
ACK Response
0.6 ms
0.85 ms
Recommended period
(approx.1.038ms)
for data sampling
for data sampling
Reference point
Page 464
<CECDAT>
34/fs ± 6/fs
1.05 ms
1.25 ms
1.5 ms
TMPM363F10FG