peb20525 Infineon Technologies Corporation, peb20525 Datasheet - Page 215

no-image

peb20525

Manufacturer Part Number
peb20525
Description
2 Channel Serial Optimized Communication Controller For Hdlc/ppp
Manufacturer
Infineon Technologies Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
peb20525F
Manufacturer:
INFINEON
Quantity:
26
Part Number:
peb20525F
Manufacturer:
infineon
Quantity:
10
Part Number:
peb20525F-V1.3
Manufacturer:
PROCONN
Quantity:
3 000
Part Number:
peb20525FV1.3
Manufacturer:
INFINEON
Quantity:
101
Part Number:
peb20525H
Manufacturer:
infineon
Quantity:
25
6
6.1
After Reset the CPU has to write a minimum set of registers and an optional set
depending on the required features and operating modes.
First, the following initialization steps must be taken:
• Select serial protocol mode (refer to
• Select encoding of the serial data (refer to
• Program the output characteristics of
• Choose a clock mode (refer to
• Power-up the oscillator unit (with or without shaper) by re-setting bit GMODE:OSCPD
The clock mode must be set before power-up (CCR0H.PU). The CPU may switch the
SEROCCO-H between power-up and power-down mode. This has no influence upon the
contents of the registers, i.e. the internal state remains stored. In power-down mode
however, all internal clocks are disabled, no interrupts from the corresponding channel
are forwarded to the CPU. This state can be used as a standby mode, when the channel
is (temporarily) not used, thus substantially reducing power consumption.
The SEROCCO-H should usually be initialized in Power-Down mode.
The need for programming further registers depends on the selected features (serial
mode, clock mode specific features, operating mode, address mode, user demands).
6.2
6.2.1
In transmit direction 2 ´ 32 byte FIFO buffers (transmit pools) are provided for each
channel. After checking the XFIFO status by polling the Transmit FIFO Write Enable bit
(bit ’XFW’ in
bytes may be entered by the CPU into the XFIFO.
The transmission of a packet can be started by issuing an ’XF’ or ’XIF’ command via the
CMDRL
and PREAMB) are sent out optionally before transmission of the current packet starts.
Data Sheet
Page
Page
- pin TxD (selected with bit ’ODS’ in
Byte)” on Page
- interrupt pin INT/INT (selected with bit field ’IPC(1:0)’ in
Page
to ’0’, if appropriate (GMODE:DSHP=’0’ enables the shaper).
83),
74),
112),
register. If enabled, a specified number of preambles (refer to registers
Programming
Initialization
Interrupt Mode
Data Transmission (Interrupt Driven)
STARL
143) and
register) or after a Transmit Pool Ready (’XPR’) interrupt, up to 32
Table 7 "Overview of Clock Modes" on Page
215
“Channel Configuration Register 1 (Low
Table 12 "Protocol Mode Overview" on
Chapter 3.2.13 “Data Encoding” on
“Global Mode Register” on
Programming
PEB 20525
PEF 20525
2000-09-14
CCR2H
47).

Related parts for peb20525