HD6417750RF240DV Renesas Electronics America, HD6417750RF240DV Datasheet - Page 572

• Manufacturer Part Number: HD6417750RF240DV
• Description: MPU 3V 16K I-TEMP,PB-FREE 208-QF
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7750r

Specifications of HD6417750RF240DV

• Core Processor: SH-4
• Core Size: 32-Bit
• Speed: 240MHz
• Connectivity: EBI/EMI, FIFO, SCI, SmartCard
• Peripherals: DMA, POR, WDT
• Number Of I /o: 28
• Program Memory Type: ROMless
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 1.4 V ~ 1.6 V
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 208-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -
• Data Converters: -

Section 13 Bus State Controller (BSC)
• Self-Refreshing
Rev.7.00 Oct. 10, 2008 Page 486 of 1074
REJ09B0366-0700
Self-refresh mode is a kind of standby mode in which the refresh timing and refresh addresses
are generated within the synchronous DRAM. Self-refreshing is activated by setting both the
RMODE bit and the RFSH bit to 1. The self-refresh state is maintained while the CKE signal
is low. Synchronous DRAM cannot be accessed while in the self-refresh state. Self-refresh
mode is cleared by clearing the RMODE bit to 0. After self-refresh mode has been cleared,
command issuance is disabled for the number of cycles specified by bits TRC2–TRC0 in
MCR. Self-refresh timing is shown in figure 13.41. Settings must be made so that self-refresh
clearing and data retention are performed correctly, and auto-refreshing is performed at the
correct intervals. When self-refreshing is activated from the state in which auto-refreshing is
set, or when exiting standby mode other than through a power-on reset, auto-refreshing is
restarted if RFSH is set to 1 and RMODE is cleared to 0 when self-refresh mode is cleared. If
the transition from clearing of self-refresh mode to the start of auto-refreshing takes time, this
time should be taken into consideration when setting the initial value of RTCNT. Making the
RTCNT value 1 less than the RTCOR value will enable refreshing to be started immediately.
After self-refreshing has been set, the self-refresh state continues even if the chip standby state
is entered using this LSI's standby function, and is maintained even after recovery from
standby mode other than through a power-on reset.
CKIO
CSn
RD/WR
RAS
CASS
DQMn
D63–D0
BS
CKE
Figure 13.40 Synchronous DRAM Auto-Refresh Timing
TRr1
TRr2
TRr3
TRr4
TRrw
TRr5
Trc
Trc
Trc