R88A-CNG02R Omron, R88A-CNG02R Datasheet - Page 398

• Manufacturer Part Number: R88A-CNG02R
• Description: Encoder Connector INC Motor
• Manufacturer: Omron

Specifications of R88A-CNG02R

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

6
6-4 Setting the Mode
Parameter Write Mode
6-19
Key operation
Key operation
1. Saving Changed Settings
2.
Returning to Parameter Write Mode
Settings changed in Parameter Setting Mode must be saved to EEPROM. To do so, the following
procedure must be performed.
Precautions
for Correct Use
Display example
Display example
If a write error occurs, write the data again. If write errors continue to occur,
there may be a fault in the Servo Drive.
Do not turn OFF the power supply while writing to EEPROM. Incorrect data
may be written if the power supply is turned OFF. If the power supply is
turned OFF, perform the settings again for all parameters, and write the
data again.
Do not disconnect the Parameter Unit from the Servo Drive during the time
from writing start (“Start”) to writing completion (“Finish” or “Reset”). If the
Parameter Unit is disconnected, repeat the procedure from the beginning.
Press the Mode key to display Parameter Write Mode.
Press the Data key to enter Parameter Write Mode.
Press the Increment key for 5 s or longer.
The bar indicator will increase.
Writing will start. (This display will appear only momentarily.)
This display indicates a normal completion. In addition to the “Finish,” either
“Reset” or “Error” may be displayed. If “Reset” is displayed, writing has been
completed normally, but some of the changed parameters will be enabled
only after the power has been turned OFF and ON again. Turn OFF the
Servo Drive power supply and then turn it ON again. “Error” is displayed if
there is a writing error. Write the data again.
Press the Data key to return to Parameter Write Mode.
Explanation
Explanation