MC68HC908AS60MFN MOTOROLA [Motorola, Inc], MC68HC908AS60MFN Datasheet - Page 274

• Manufacturer Part Number: MC68HC908AS60MFN
• Description: HCMOS Microcontroller Unit
• Manufacturer: MOTOROLA [Motorola, Inc]

Serial Peripheral Interface (SPI)
18.8 Interrupts
Technical Data
274
NOTE:
NOTE:
transmission begins when the SPSCK leaves its idle level and SS is
already low. The transmission continues until the SPSCK returns to its
IDLE level after the shift of the last data bit. (See
Formats).
When CPHA = 0, a MODF occurs if a slave is selected (SS is at logic 0)
and later unselected (SS is at logic 1) even if no SPSCK is sent to that
slave. This happens because SS at logic 0 indicates the start of the
transmission (MISO driven out with the value of MSB) for CPHA = 0.
When CPHA = 1, a slave can be selected and then later unselected with
no transmission occurring. Therefore, MODF does not occur since a
transmission was never begun.
In a slave SPI (MSTR = 0), the MODF bit generates an SPI
receiver/error CPU interrupt request if the ERRIE bit is set. The MODF
bit does not clear the SPE bit or reset the SPI in any way. Software can
abort the SPI transmission by toggling the SPE bit of the slave.
A logic 1 voltage on the SS pin of a slave SPI puts the MISO pin in a high
impedance state. Also, the slave SPI ignores all incoming SPSCK
clocks, even if a transmission has begun.
To clear the MODF flag, read the SPSCR and then write to the SPCR
register. This entire clearing procedure must occur with no MODF
condition existing or else the flag will not be cleared.
The four SPI status flags that can be enabled to generate CPU interrupt
requests are listed in
SPTE (transmitter empty)
SPRF (receiver full)
OVRF (overflow)
MODF (mode fault)
Freescale Semiconductor, Inc.
For More Information On This Product,
Flag
Serial Peripheral Interface (SPI)
Go to: www.freescale.com
Table
Table 18-3. SPI Interrupts
SPI transmitter CPU interrupt request (SPTIE = 1)
SPI receiver CPU interrupt request (SPRIE = 1)
SPI receiver/error interrupt request
SPI receiver/error interrupt request
(ERRIE = 1)
(ERRIE = 1, MODFEN = 1)
18-3.
Request
MC68HC908AS60 — Rev. 1.0
18.6 Transmission
MOTOROLA