ATA6613-EK Atmel, ATA6613-EK Datasheet - Page 102

• Manufacturer Part Number: ATA6613-EK
• Description: BOARD DEMO LIN-MCM FOR ATA6613
• Manufacturer: Atmel

Specifications of ATA6613-EK

• Main Purpose: Interface, LIN + MCU
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ATA6613
• Primary Attributes: LIN-SBC (System-Basis-Chip) Transceiver, LIN 2.0, Voltage Regulator, Window Watchdog
• Secondary Attributes: 16 kB Flash, 4 Power Modes: Pre-Normal, Normal, Sleep, Silent, 48-QFN
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

102
Atmel ATA6612/ATA6613
• SDA/ADC4/PCINT12 – Port C, Bit 4
• ADC3/PCINT11 – Port C, Bit 3
• ADC2/PCINT10 – Port C, Bit 2
• ADC1/PCINT9 – Port C, Bit 1
• ADC0/PCINT8 – Port C, Bit 0
SDA, 2-wire Serial Interface Data: When the TWEN bit in TWCR is set (one) to enable the
2-wire Serial Interface, pin PC4 is disconnected from the port and becomes the Serial
Data I/O pin for the 2-wire Serial Interface. In this mode, there is a spike filter on the pin to
suppress spikes shorter than 50 ns on the input signal, and the pin is driven by an open
drain driver with slew-rate limitation.
PC4 can also be used as ADC input Channel 4. Note that ADC input channel 4 uses digi-
tal power.
PCINT12: Pin Change Interrupt source 12. The PC4 pin can serve as an external interrupt
source.
PC3 can also be used as ADC input Channel 3. Note that ADC input channel 3 uses ana-
log power.
PCINT11: Pin Change Interrupt source 11. The PC3 pin can serve as an external interrupt
source.
PC2 can also be used as ADC input Channel 2. Note that ADC input channel 2 uses ana-
log power.
PCINT10: Pin Change Interrupt source 10. The PC2 pin can serve as an external interrupt
source.
PC1 can also be used as ADC input Channel 1. Note that ADC input channel 1 uses ana-
log power.
PCINT9: Pin Change Interrupt source 9. The PC1 pin can serve as an external interrupt
source.
PC0 can also be used as ADC input Channel 0. Note that ADC input channel 0 uses ana-
log power.
PCINT8: Pin Change Interrupt source 8. The PC0 pin can serve as an external interrupt
source.
9111H–AUTO–01/11