ATA6613-EK Atmel, ATA6613-EK Datasheet - Page 361

• Manufacturer Part Number: ATA6613-EK
• Description: BOARD DEMO LIN-MCM FOR ATA6613
• Manufacturer: Atmel

Specifications of ATA6613-EK

• Main Purpose: Interface, LIN + MCU
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ATA6613
• Primary Attributes: LIN-SBC (System-Basis-Chip) Transceiver, LIN 2.0, Voltage Regulator, Window Watchdog
• Secondary Attributes: 16 kB Flash, 4 Power Modes: Pre-Normal, Normal, Sleep, Silent, 48-QFN
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

12. Revision History
9111H–AUTO–01/11
Please note that the following page numbers referred to in this section refer to the specific revision
mentioned, not to this document.
Revision No.
9111H-AUTO-01/11
9111G-AUTO-05/10
9111F-AUTO-12/08
9111E-AUTO-07/08
9111D-AUTO-06/08
9111C-AUTO-02/08
9111B-AUTO-11/07
History
15 changed
on page 357 changed
Off during Sleep Mode” on page 358 added
on page 45 changed
on page 357 added
Section 3.1 “Features” on page 5 changed
Section 3.3.3 “Ground Pin” on page 7 changed
Section 3.3.12 “Mode Input Pin (Mode)” on page 8 changed
Figure 3.2 “Modes of Operation” on page 10 changed
Section 3.3.20.4 “Fail-safe Mode” on page 13 changed
Section 3.3.23 “Voltage Regulator” on pages 16 to 17 changed
Section 6 “Electrical Characteristics” on pages 21 to 26 changed
Table 2-2 “Maximum Ratings of the SiP” on page 4 changed
Section 3.1 “Features” on page 5 changed
Section 3.2 “Description” on page 5 changed
Section 3.3.1 “Physical Layer Compatibility” on page 7 changed
Section 3.3.6 “Bus Pin LIN” on page 7 changed
Section 3.3.8 “TX Dominant Time-out Function” on page 8 changed
Section 3.3.10 “Enable Input Pin (EN)” on page 8 changed
Section 3.3.14 “KL_15 Pin” on page 9 changed
Section 3.3.20 “Modes of Operation” on pages 10 to 14 changed
Section 3.3.21 “Wake-up Scenarios from Silent to Sleep Mode on page
Section 3.3.23 “Voltage Regulator” on page 16 changed
Section 6 “Electrical Characteristics” on page 23 changed
Section 7.7.7.1 “Power Reduction Register” on page 66 changed
Section 11 “Errata” on page 360 changed
Table 2-2 “Maximum Ratings of the SiP” on page 4 changed
Section 4 “Absolute Maximum Ratings” on page 20 changed
Figure 8-1 “Typical LIN Slave Application” on page 355 changed
Figure 8-2 “Typical LIN Master Application” on page 356 changed
Figure 8-3 “LIN Slave Application with Minimum External Components”
Figure 8-4 “Typical LIN Master Application LIN Master Pull-up Switched
Figure 3-1 “Block Diagram” on page 6 changed
Section 3.3 “Functional Description” on pages 7 to 18 changed
Section 6.5.3.2 “The EEPROM Address Register – EEARH and EEARL”
Figure 8-2 “Typical LIN Master Application” on page 356 changed
Section 5 “Electrical Characteristics” on pages 21 to 26 changed
Section 6.6.6 “Calibrated Internal RC Oscillator” on page 57 changed
Figure 8-3 “LIN Slave Application with Minimum External Components
Atmel ATA6612/ATA6613
361