ATA6613-EK Atmel, ATA6613-EK Datasheet - Page 66

• Manufacturer Part Number: ATA6613-EK
• Description: BOARD DEMO LIN-MCM FOR ATA6613
• Manufacturer: Atmel

Specifications of ATA6613-EK

• Main Purpose: Interface, LIN + MCU
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ATA6613
• Primary Attributes: LIN-SBC (System-Basis-Chip) Transceiver, LIN 2.0, Voltage Regulator, Window Watchdog
• Secondary Attributes: 16 kB Flash, 4 Power Modes: Pre-Normal, Normal, Sleep, Silent, 48-QFN
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

6.7.7.1
66
Atmel ATA6612/ATA6613
Power Reduction Register - PRR
Initial Value
Read/Write
• Bit 7 - PRTWI: Power Reduction TWI
• Bit 6 - PRTIM2: Power Reduction Timer/Counter2
• Bit 5 - PRTIM0: Power Reduction Timer/Counter0
• Bit 4 - Res: Reserved bit
• Bit 3 - PRTIM1: Power Reduction Timer/Counter1
• Bit 2 - PRSPI: Power Reduction Serial Peripheral Interface
• Bit 1 - PRUSART0: Power Reduction USART0
• Bit 0 - PRADC: Power Reduction ADC
Writing a logic one to this bit shuts down the TWI by stopping the clock to the module.
When waking up the TWI again, the TWI should be re initialized to ensure proper
operation.
Writing a logic one to this bit shuts down the Timer/Counter2 module in synchronous
mode (AS2 is 0). When the Timer/Counter2 is enabled, operation will continue like before
the shutdown.
Writing a logic one to this bit shuts down the Timer/Counter0 module. When the
Timer/Counter0 is enabled, operation will continue like before the shutdown.
This bit is reserved in Atmel
Writing a logic one to this bit shuts down the Timer/Counter1 module. When the
Timer/Counter1 is enabled, operation will continue like before the shutdown.
If using debugWIRE On-chip Debug System, this bit should not be written to one. Writing a
logic one to this bit shuts down the Serial Peripheral Interface by stopping the clock to the
module. When waking up the SPI again, the SPI should be re-initialized to ensure proper
operation.
Writing a logic one to this bit shuts down the USART by stopping the clock to the module.
When waking up the USART again, the USART should be re-initialized to ensure proper
operation.
Writing a logic one to this bit shuts down the ADC. The ADC must be disabled before shut
down. The analog comparator cannot use the ADC input MUX when the ADC is shut
down.
Bit
PRTWI
R/W
7
0
PRTIM2
R/W
6
0
PRTIM0
®
R/W
5
0
ATA6612/ATA6613 and will always read as zero.
R
4
–
0
PRTIM1
R/W
3
0
PRSPI
R/W
2
0
PRUSART0
R/W
1
0
PRADC
9111H–AUTO–01/11
R/W
0
0
PRR