ATA6613-EK Atmel, ATA6613-EK Datasheet - Page 11

• Manufacturer Part Number: ATA6613-EK
• Description: BOARD DEMO LIN-MCM FOR ATA6613
• Manufacturer: Atmel

Specifications of ATA6613-EK

• Main Purpose: Interface, LIN + MCU
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ATA6613
• Primary Attributes: LIN-SBC (System-Basis-Chip) Transceiver, LIN 2.0, Voltage Regulator, Window Watchdog
• Secondary Attributes: 16 kB Flash, 4 Power Modes: Pre-Normal, Normal, Sleep, Silent, 48-QFN
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

3.3.20.1
3.3.20.2
9111H–AUTO–01/11
Normal Mode
Silent Mode
This is the normal transmitting and receiving mode at the LIN interface in accordance with the
LIN specification LIN 2.x. The voltage regulator is active and can source up to 50 mA. The
undervoltage detection is activated. The watchdog needs a trigger signal from NTRIG to avoid
resets at NRES. If NRES is switched to low, the IC changes its state to Fail-safe Mode.
A falling edge at EN when TXD is high switches the IC into Silent Mode. The TXD Signal has
to be logic high during the Mode Select window (see
path is disabled in Silent Mode. The overall supply current from V
I
The 5V regulator with ±2% tolerance can source up to 50mA. The internal slave termination
between the LIN pin and the VS pin is disabled in Silent Mode, only a weak pull-up current
(typically 10µA) between the LIN pin and the VS pin is present. Silent Mode can be activated
independently from the actual level on the LIN, WAKE, or KL_15 pins.
If an undervoltage condition occurs, NRES is switched to low, and the IC changes its state to
Fail-safe Mode.
A voltage less than the LIN Pre_Wake detection VLINL at the LIN pin activates the internal LIN
receiver and switches on the internal slave termination between the LIN pin and the V
Figure 3-3.
VSsi
57µA plus the VCC regulator output current I
NRES
VCC
TXD
LIN
EN
Normal Mode
Switch to Silent Mode
LIN switches directly to recessive mode
t
d
_sleep = maximum 20µs
Delay time silent mode
t
d
= 3.2µs
Mode select window
Atmel ATA6612/ATA6613
VCC
.
Figure 3-3 on page
Silent Mode
Batt
is a combination of the
11). The transmission
S
pin.
11