MCF5214CVF66 Freescale Semiconductor, MCF5214CVF66 Datasheet - Page 157

• Manufacturer Part Number: MCF5214CVF66
• Description: IC MPU 32BIT COLDF 256-MAPBGA
• Manufacturer: Freescale Semiconductor
• Series: MCF521xr

Specifications of MCF5214CVF66

• Core Processor: Coldfire V2
• Core Size: 32-Bit
• Speed: 66MHz
• Connectivity: CAN, EBI/EMI, I²C, SPI, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 142
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 64K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 256-MAPBGA
• Package: 256MA-BGA
• Device Core: ColdFire
• Family Name: MCF521x
• Maximum Speed: 66 MHz
• Operating Supply Voltage: 3.3 V
• Data Bus Width: 32 Bit
• Number Of Programmable I/os: 142
• Interface Type: QSPI/UART/I2C/CAN
• On-chip Adc: 8-chx10-bit
• Number Of Timers: 8
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

8.4.3
The CRSR contains a bit for two of the reset sources to the CPU. A bit set to 1 indicates the last type of
reset that occurred. The CRSR is updated by the control logic when the reset is complete. Only one bit is
set at any one time in the CRSR. The register reflects the cause of the most recent reset. To clear a bit, a
logic 1 must be written to the bit location; writing a zero has no effect.
8.4.4
The core watchdog timer prevents system lockup if the software becomes trapped in a loop with no
controlled exit. The core watchdog timer can be enabled or disabled through CWCR[CWE]. By default it
is disabled. If enabled, the watchdog timer requires the periodic execution of a core watchdog servicing
sequence. If this periodic servicing action does not occur, the timer times out, resulting in a watchdog timer
interrupt. If the timer times out and the core watchdog transfer acknowledge enable bit (CWCR[CWTA])
is set, a watchdog timer interrupt is asserted. If a core watchdog timer interrupt acknowledge cycle has not
occurred after another timeout, CWT TA is asserted in an attempt to allow the interrupt acknowledge cycle
to proceed by terminating the bus cycle. The setting of CWCR[CWTAVAL] indicates that the watchdog
timer TA was asserted.
Freescale Semiconductor
Bits
6-0
7
Core Reset Status Register (CRSR)
Core Watchdog Control Register (CWCR)
Name
EXT
—
The reset status register (RSR) in the reset controller module (see
Chapter 29, “Reset Controller
sources except the core watchdog timer.
The core watchdog timer is available to provide compatibility with the
watchdog timer implemented on previous ColdFire devices. However, there
is a second watchdog timer available that has new features. See
“Watchdog Timer
Address
External reset.
1 An external device driving RSTI caused the last reset. Assertion of reset by an external device
Reserved.
Reset
causes the processor core to initiate reset exception processing. All registers are forced to their
initial state.
Field
R/W
MCF5282 and MCF5216 ColdFire Microcontroller User’s Manual, Rev. 3
Note: The reset value of EXT and CWDR depend on the last reset
source. All other bits are initialized to zero.
EXT
Figure 8-3. Core Reset Status Register (CRSR)
7
Module” for more information.
Table 8-4. CRSR Field Descriptions
6
5
Module”) provides indication of all reset
NOTE
NOTE
IPSBAR + 0x010
4
See Note
Description
R/W
—
Chapter 18,
System Control Module (SCM)
0
8-5