DF2398F20V Renesas Electronics America, DF2398F20V Datasheet - Page 254

• Manufacturer Part Number: DF2398F20V
• Description: IC H8S/2300 MCU FLASH 128QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2398F20V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 87
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• For Use With: YR0K42378FC000BA - KIT EVAL FOR H8S/2378
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

DREQ Level Activation Timing (Normal Mode): Set the DTA bit for the channel for which the DREQ pin is selected to
1.
Figure 7-25 shows an example of DREQ level activated normal mode transfer.
DREQ pin sampling is performed every cycle, with the rising edge of the next ø cycle after the end of the DMABCR write
cycle for setting the transfer enabled state as the starting point.
When the DREQ pin low level is sampled while acceptance by means of the DREQ pin is possible, the request is held in
the DMAC. Then, when activation is initiated in the DMAC, the request is cleared. After the end of the write cycle,
acceptance resumes, DREQ pin low level sampling is performed again, and this operation is repeated until the transfer
ends.
Rev.6.00 Oct.28.2004 page 224 of 1016
REJ09B0138-0600H
Address bus
DMA control
[1]
[2] [5]
[3] [6]
[4] [7]
Note: In write data buffer mode, bus breaks from [2] to [7] may be hidden, and not visible.
Channel
DREQ
Figure 7-25 Example of DREQ Level Activated Normal Mode Transfer
Acceptance after transfer enabling; the DREQ pin low level is sampled on the rising
edge of ø, and the request is held.
The request is cleared at the next bus break, and activation is started in the DMAC.
The DMA cycle is started.
Acceptance is resumed after the write cycle is completed.
(As in [1], the DREQ pin low level is sampled on the rising edge of ø, and the request is held.)
ø
Idle
Minimum of 2 cycles
[1]
Request
release
Bus
[2]
Read
[3]
Request clear period
Transfer
DMA
source
read
Write
destination
Transfer
DMA
write
Idle
Acceptance resumes
Minimum of 2 cycles
[4]
Request
release
Bus
[5]
Read
[6]
Request clear period
Transfer
DMA
read
source
Write
destination
DMA
Transfer
write
Idle
Acceptance resumes
[7]
release
Bus