PNX1501E NXP Semiconductors, PNX1501E Datasheet - Page 526

• Manufacturer Part Number: PNX1501E
• Description: Digital Signal Processors & Controllers (DSP, DSC) MEDIA PROCESSOR PNX15XX/266MHZ
• Manufacturer: NXP Semiconductors

Specifications of PNX1501E

• Product: DSPs
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: SOT-795
• Minimum Operating Temperature: 0 C
• Lead Free Status / Rohs Status: Details
• Other names: PNX1501E,557

Philips Semiconductors
Volume 1 of 1
12NC 9397 750 14321
Product data sheet
3.3 Register Programming Guidelines
3.4 Serial Data Framing
Clocks are required to be running during HW/SW reset because synchronous reset is
used to initialize the logic. The unique feature with Audio is that unlike all other blocks
in the system, the Audio blocks default to the external clock source on any reset. If
the external clock does not exist when a HW reset is applied, then the logic is left
uninitialized without any indication.
Software needs to ensure that the cap_enable bit (bit 30, AI_CTL) is programmed
after all the other registers have been programmed to ensure proper functionality.
Disabling and re-enabling capture
Here is a brief discussion on how the audio in block works if for some reason software
needs to disable the capture and consequently re-enable it. The Audio Input module
is continuously capturing and transferring data to memory through the adapter in the
system. The adapter threshold should be suitably set to satisfy the system latency
requirements. Once the adapter FIFO reaches the threshold, it will initiate a transfer
to memory. This behavior will continue until the capture is disabled. Once the capture
is disabled, the Audio In block will issue a FLUSH to the adapter so that it can flush its
FIFO and hence all the pertinent data that would reach memory. However, it must be
understood that disabling capture is not the same as applying software reset. Even
though capture is disabled, all the internal DMA state machines have pointers
pointing to addresses in memory corresponding to the transaction that was just
completed. So if the software intends to re-enable capture from scratch with new
pointers, there needs to be a software reset performed between disabling and re-
enabling the capture, along with optional reprogramming of the registers. Failure to
do a software reset will result in the Audio Input module behaving as though the
previous transaction is continuing with all the previous pointers active.
The Audio In unit can accept data in a wide variety of serial data framing conventions.
Figure 3
and EARLYMODE=0, a frame is defined with respect to the positive transition of the
WS signal as observed by a positive clock transition on SCK. (See
data bit sampled on positive SCK transitions has a specific bit position—i.e., once the
clock edge detects the WS transition, the next sample will be data bit position 0.
illustrates the notion of a serial frame. If POLARITY = 1, CLOCK_EDGE = 0,
Rev. 2 — 1 December 2004
© Koninklijke Philips Electronics N.V. 2002-2003-2004. All rights reserved.
PNX15xx Series
Chapter 16: Audio Input
Section
4..) Each
16-7