HD6432670 Hitachi, HD6432670 Datasheet - Page 726

• Manufacturer Part Number: HD6432670
• Description: (HD64F267x Series) 16-Bit Microcomputer
• Manufacturer: Hitachi

15.6.2
Before transmitting and receiving data, you should first clear the TE and RE bits in SCR to 0, then
initialize the SCI as described in a sample flowchart in figure 15.15. When the operating mode,
transfer format, etc., is changed, the TE and RE bits must be cleared to 0 before making the
change. When the TE bit is cleared to 0, the TDRE flag is set to 1. Note that clearing the RE bit
to 0 does not change the contents of the RDRF, PER, FER, and ORER flags, or the contents of
RDR.
Rev. 2.0, 04/02, page 680 of 906
Note: In simultaneous transmit and receive operations, the TE and RE bits should
Set TE and RE bits in SCR to 1, and
set RIE, TIE, TEIE, and MPIE bits
Clear TE and RE bits in SCR to 0
Set CKE1 and CKE0 bits in SCR
SCI Initialization (Clocked Synchronous Mode)
Set data transfer format in
both be cleared to 0 or set to 1 simultaneously.
1-bit interval elapsed?
Start of initialization
Set value in BRR
SMR and SCMR
<Transfer start>
(TE, RE bits 0)
Figure 15.15 Sample SCI Initialization Flowchart
Yes
Wait
No
[4]
[2]
[3]
[1]
[1] Set the clock selection in SCR. Be sure
[2] Set the data transfer format in SMR
[3] Write a value corresponding to the bit
[4] Wait at least one bit interval, then set
to clear bits RIE, TIE, TEIE, and MPIE,
TE and RE, to 0.
and SCMR.
rate to BRR. (Not necessary if an
external clock is used.)
the TE and RE bits in SCR to 1.
Also set the RIE, TIE, TEIE, and MPIE
bits.
Setting the TE and RE bits enable the
TxD and RxD pins to be used.